MANIFOLD 9M4317 - Caterpillar

Illustration 11 g03358619
Install elbow (10). Connect tube assembly (9).
Illustration 12 g03358572
Connect hose assembly (8).
Illustration 13 g03358555
Position cover (7) and install bolt (6).
Illustration 14 g03358548
Position elbow (5) and install bolts (4). Connect hose assembly (3) to tilt cylinder (1). Connect hose assemblies (2). End By:
Separate the steering frame lock. Disassembly and Assembly Information
Table 3
Required Tools
Tool Part Number Part Description Qty
C 127-4904 Hydraulic Cylinder Repair Stand Gp 1
D Loctite Retaining Compound 620 1
E 1P-0808 Multipurpose Grease 1
F 7M-7456 Bearing Mount Compound 1
G 350-7768 Electric Hydraulic Pump Gp (115V) 1
350-7769 Electric Hydraulic Pump Gp (230V) 1
1P-1833 Adapter 1
4C-9633 Puller Stud 1
1A-1935 Full Nut 1
6V-3160 Double Acting Cylinder 1
9S-5565 Pin Puller Sleeve As 1
H 1P-0510 Driver Gp 1
J 9U-7868 Spanner Wrench. 1
127-8064 Adapter Plate Gp 1
K 195-4609 Seal Pick 1
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
When you are using hydraulic cylinders and puller studs, always ensure that the rated capacity of the puller stud meets or exceeds the rated capacity of the hydraulic cylinder. If the puller stud does not meet or exceed the rated capacity of the hydraulic cylinder, a sudden failure of the puller stud could occur. The sudden failure of the puller stud could result in personal injury or death.
Cylinders equipped with lock valves can remain pressurized for very long periods of time, even with the hoses removed.Failure to relieve pressure before removing a lock valve or disassembling a cylinder can result in personal injury or death.Ensure all pressure is relieved before removing a lock valve or disassembling a cylinder.
Illustration 15 g03358712
Lubricate the threads of nut (3). Tighten nut (3) to a torque of 5200 520 N m (3835 385 lb ft).
Apply Tooling (D) to wiper seal (9) groove prior to assembly.
Lubricate the sealing lips of seals (7), (8), and (9) with the fluid that is being sealed.
Tighten bolts (4) to a torque of 1050 150 N m (775 111 lb ft).
Install bearing sleeves (1) and (5) to a depth of 9.5 0.5 mm (0.37 0.02 inch) from the face of the bore. Note: Do not use an impact type driver to install the bearings.
Lubricate seals (2) and (6) with the lubricant that is being sealed. Note: The lips of seals (2) and (6) must not protrude above the face of the bore.