MARKER 7W3470 - Caterpillar

Illustration 1 g01048234
(1) Machine PIN ____________________ (2) Transmission Serial Number ____________________
Illustration 2 g01046668
Engine Serial Number ____________________
Illustration 3 g00407919
Winch Serial Number (boom) ____________________Winch Serial Number (hook) ____________________Certification
ROPS
If equipped, this message is located on the vertical support of the ROPS on the right side of the machine.
Illustration 4 g01025777
Structural damage, an overturn, modification, alteration, or improper repair, can impair this structure's protective capability thereby voiding this certification. Do not weld on or drill holes in the structure. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification.
This machine has been certified to the standards that are listed on the certification film. The maximum mass of the machine, which includes the operator and the attachments without a payload, should not exceed the mass on the certification film.A typical example of the certification film is shown above.Refer to Operation and Maintenance Manual, "Guards (Operator Protection)" for more information.European Union
Illustration 5 g01025766
This plate is positioned on the PIN plate on left side of the frame.
PIN____________________
Model____________________
Power (kW)____________________
Weight (kg)____________________Sound
This film is located on the left console outside the armrest.
Illustration 6 g00933634
A typical example of this film is shown. Your machine may have a different value.If equipped, the sound certification film is used to verify the environmental sound certification of the machine. The value that is listed on the film indicates the guaranteed sound power level. The guaranteed sound power level is measured at the time of manufacture. The guaranteed sound power level is measured according to the conditions that are specified in "2000/14/EC".Product Link
If equipped, this message is used to verify the certification of the Product Link as a RF transmitter. The following specifications are provided to aid in ensuring compliance with all local regulations:
Table 1
Operating frequency range     148 to 150 MHz    
Transmitter power     5 Watts    This message is located on the control group for the product link. The control group is located under the operator's seat.
Illustration 7 g01040349
If the machine is required to work within 6 m (20 ft) of a blast area, power to the Product Link module must be disconnected.Consult your Caterpillar dealer with any questions that concern the operation of the Product Link in a specific country.