MAT 2252450 - Caterpillar

Illustration 1 g00832227
(A) Bucket Cylinder (B) Bucket Control Linkage (C) Bucket (D) Boom (E) Stick CylinderNote: All bores must be free of paint. Coat all bores for pins with lubricant. (1) 1R-6224 Pin Assembly Diameter after plating ... 59.86 0.03 mm (2.3567 0.0012 inch) Minimum thickness for plating ... 0.005 mm (0.0002 inch) Bore diameter for pin ... 60.0 mm (2.3622 inch) (2) 1R-6225 Pin Assembly Diameter after plating ... 59.86 0.03 mm (2.3567 0.0012 inch) Minimum thickness for plating ... 0.005 mm (0.0002 inch) Bore diameter for pin ... 60.0 mm (2.3622 inch) (3) Use the necessary shims to adjust the lateral clearance. 166-1481 Shim thickness ... 2.00 0.15 mm (0.079 0.006 inch) (4) Lubricate the sealing lip slightly with the lubricant that is being sealed. (5) Two 168-0062 Sleeve Bearings Outside diameter ... 95.112 0.011 mm (3.7446 0.0004 inch) Inside diameter ... 80.25 0.02 mm (3.159 0.001 inch) Install the bearing in the bearing bore. ... 9.5 0.8 mm (0.37 0.03 inch) (6) Two 143-3835 Sleeve Bearings Outside diameter ... 75.085 0.01 mm (2.9561 0.0004 inch) Inside diameter ... 60.162 0.037 mm (2.3686 0.0015 inch) Install the bearing in the bearing bore. ... 5.5 0.8 mm (0.22 0.03 inch) (7) Two 189-3870 Sleeve Bearings Outside diameter ... 80.140 0.013 mm (3.1551 0.0005 inch) Inside diameter ... 65.227 0.037 mm (2.5680 0.0015 inch) Install the bearing in the bearing bore. ... 5.5 0.8 mm (0.22 0.03 inch)