MEDIUM ARM ASSY. 0990716 - Caterpillar

Illustration 19 g01171887
Connect hose assemblies (34) , (35) , (36) , (37) , (38) , (39) , (40) , (41) and (42) .
Illustration 20 g01171882
Install bolts (32) and (33) .
Illustration 21 g01171881
Install Tooling (B) and a suitable lifting device to steering control valve (31) . The weight of steering control valve (31) is approximately 45 kg (99 lb).
Install steering control valve (31) and three bolts (30) .
Illustration 22 g01171880
Position manifold (27) and hose assembly (29) .
Connect hose assemblies (28) and (26) .
Illustration 23 g01171879
Connect hose assembly (24) .
Connect hose assembly (25) and tighten two clamps (23) .
Illustration 24 g01171878
Install clips (21) and (22) .
Illustration 25 g01171875
Install clip (20) .
Illustration 26 g01171361
Install the electrical harness, clip (18) , two bolts (19) and cable strap (17) .
Connect electrical connector (16) and install to the clip.
Illustration 27 g01171359
Install filter assembly (12) and four bolts (11) (not shown).
Connect hose assemblies (13) , (14) and (15) .
Illustration 28 g03795114
Connect hose assembly (10) .
Illustration 29 g01171356
Install two bolts (5) .
Connect electrical connector (9) .
Connect hose assemblies (6) , (7) and (8) .
Illustration 30 g01171353
Install covers (2) , (3) and (4) .
Illustration 31 g01096820
Attach a suitable lifting device to cover (1) . The weight of cover (1) is approximately 65 kg (145 lb). Install cover (1) .
Fill the transmission. Refer to Operation and Maintenance Manual, "Capacities (Refill)" for the capacity of the transmission. Refer to Operation and Maintenance Manual, "Transmission Oil - Change" for the correct filling procedure.
Check the hydraulic system oil level. Refer to Operation and Maintenance Manual, "Hydraulic System Oil Level - Check".
Purge the air from the braking system. Refer to Systems Operation, Testing and Adjusting, "Braking System Air - Purge".End By:
Install the secondary steering pump. Refer to Disassembly and Assembly, "Secondary Steering Pump - Install".
Install the front drive shaft. Refer to Disassembly and Assembly, "Front Drive Shaft - Remove and Install".
Install the upper drive shaft. Refer to Disassembly and Assembly, "Upper Drive Shaft - Remove and Install".
Remove the body retaining pins. Refer to Disassembly and Assembly, "Body Retaining Pins - Remove and Install".
Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".