METER GP-SERVICE 3660368 - Caterpillar

Disassembly Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-0520 Driver Gp 1 Start By:
Remove the final drive, the wheel, and the service brake piston housing . Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be cleaned thoroughly. Cleaning will help to prevent dirt from entering the internal mechanism.
Illustration 1 g03692277
Position spindle assembly (1) in a vertical position with the brake assembly facing upward.
Remove O-ring seal (2).
Remove retaining ring (3).
Remove hub (4) from spindle assembly (1).
Illustration 2 g03692519
Remove outer plate (5), friction disc (6), outer plate (7), friction disc (8), outer plate (9), friction disc (10), outer plate (11), friction disc (12), and outer plate (13) from spindle assembly (1). Note: Steps 6 through 12 are for the disassembly of the service brake piston housing.
Illustration 3 g03692526
Illustration 4 g03692531
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Use Tooling (A) and a suitable press in order to compress springs (17) on piston housing (14).
Remove retaining pins (15) (not shown) from spring guides (16).
Release the pressure from the suitable press. Remove springs (17) and spring guides (16) from piston housing (14).
Illustration 5 g03692532
Remove retaining ring (18), hard washer (19), and pin (20) from piston housing (14).
Illustration 6 g03692534
Remove hollow dowel (21) and O-ring seal (22) from piston housing (14).
Illustration 7 g03692536
Typical Example
To separate piston (23) from piston housing (14), block purge port (25) and apply a small amount of pressure to pressure port (24). Remove piston (23) from piston housing (14).
Illustration 8 g03692539
Remove outer seal (26) and inner seal (27) from piston housing (14).