METER-SLOPE 5311063 - Caterpillar

Illustration 4 g03741605
Illustration 5 g03741607
Press throttle control switch (3) in order to place the engine in low idle.Note: Two things indicate when the engine is at low idle. First, the engine rpm will appear on machine display (4). Second, the indicator light next to the throttle switch will go out.
Illustration 6 g03737031
Move engine start switch (5) to the OFF position in order to shut off the engine.
Illustration 7 g03745154
Note: The weight of the belly pan is over 23 kg (50 lb). Use two people to lift this component.
Remove 11 bolts (6) and washers. Remove rear belly pan (7) .
Illustration 8 g03745163
Locate the charge supply tee (9) on the right side of the machine. Disconnect charge supply hose (8) to the left propulsion pump.
Illustration 9 g03745183
Install cap (B) on tee (9). Install plug (C) on charge supply hose (8) .
Illustration 10 g03745200
Connect Tool (A2) to front charge pressure tap (10) on charge filter group (11) .Test Procedure
Move engine start switch (5) to the START position. Release the engine start switch when the engine starts.
Press throttle switch (3) once to the place the engine in high idle. Engine speed should be 2200 50 rpm.Note: Two things indicate when the engine is at high idle. First, the engine rpm will appear on machine display (4). Second, an indicator light next to the throttle switch will illuminate.
Operate the engine at high idle. Monitor the hydraulic oil temperature on machine display (4). Operate the machine until the oil temperature reaches 40° C (104° F).
With propulsion lever (1) in the NEUTRAL position and the engine at high idle, read the pressure on Tool (A1). The pressure should be 3310 280 kPa (480 41 psi).
Press throttle control switch (3) in order to place the engine in low idle.Note: Two things indicate when the engine is at low idle. First, the engine rpm will appear on machine display (4). Second, the indicator light next to the throttle switch will go out.
Move engine start switch (5) to the OFF position in order to shut off the engine.
If the pressure is not within the specified range, go to "Adjustment Procedure". If the pressure is within the specified range, go to Step 8.
Remove the tooling.
Connect charge supply hose (8) to the left propulsion pump to charge supply tee (9) on the right side of the machine.Note: The weight of the belly pan is over 23 kg (50 lb). Use two people to lift this component.
Position rear belly pan (7). Secure with 11 bolts (6) and washers.Adjustment Procedure
Move engine start switch (5) to the START position. Release the engine start switch when the engine starts.
Illustration 11 g03745643
Press operator station slide left switch (12) to move the operator station to the LEFT position. An indicator light will illuminate when the operator station slide left switch is activated. Release the switch when the operator station reaches the left side of the machine.
Illustration 12 g03745644
Open right access door (13) on the deck.
Illustration 13 g03745450
Illustration 14 g03745453
Loosen locknut (15) on charge relief valve (14). In order to increase pressure, rotate adjustment screw