MIRROR AS 2806070 - Caterpillar

No clearance for person in this area when machine turns. Severe injury or death from crushing could occur.
"Connect steering frame lock between front and rear frames before lifting, transporting, or servicing machine in articulation area.""Disconnect lock and secure before resuming operation."Battery (6)This warning is located near the auxiliary start receptacle.
g01370909
There is limited battery access. Jump starting at the battery, or improper jumper cable connections at the starter, can cause explosion resulting in personal injury.Do not jump start the machine at the battery. Use the remote starting receptacle or jump start to the positive battery post on the starter.If remote starting receptacle can not be used, jumper cables may be used at the starter. Always connect the positive (+) cable to positive (+) terminal of the starter and connect negative (-) cable from external source to engine block. Follow procedure from the Operation and Maintenance Manual.
Pressurized System (7)This warning label is located near the cooling system pressure cap.
g01371640
PRESSURIZED SYSTEM: HOT COOLANT CAN CAUSE SERIOUS BURN. TO OPEN CAP, STOP ENGINE, WAIT UNTIL RADIATOR IS COOL. THEN LOOSEN CAP SLOWLY TO RELIEVE THE PRESSURE.
Do Not Weld on the ROPS (8)This warning label is located on the outside of the cab on the right side.
g01212098
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification.
"Rollover Protective Structure (ROPS) and Falling Object Protective Structure (FOPS) Certification""This structure, when properly installed on a machine which is not altered to exceed the certification test mass meets, at the time of installation, criteria established by: , SAE J1040 MAY 94, ISO 3471: 1994, SAEJ/ISO 3449 APR 98 LEVEL II, ISO 3449: 1992 LEVEL II"Product Link (9)This warning label is located on the left front ROPS post inside the cab.
g01370917
This machine is equipped with a Caterpillar Product Link communication device which must be deactivated within 12 m (40 ft) of a blast zone. Failure to do so could result in serious injury or death.
Refer to Special Instruction, REHS1642, "Operation of Product Link" for additional information. Also, see listing in "Reference Material".Compressed Spring (10)This warning label is located on the parking brake actuator.
g01379131
Do not attempt to remove spring(s), they are not serviceable. Do not cut, saw, torch or modify this chamber, serious injury or death may result.
Falling Hazard (11)
Illustration 2 g01397286
This warning is located on each side of the machine. This location may be on the fenders or near the top of the fuel tank.
Fall Hazard. Severe injury or death could occur from falling while servicing components on the machine at elevated positions. Use proper precautions and / or external access devices.