MIRROR-CONVEX 3533587 - Caterpillar

Before the torque divider is assembled, measurements of certain clearances must be made if the torque divider is to operate with efficiency.1. Check the clearance between the turbine wheel and stator as follows: a. Put stator (25) in position in turbine wheel (32). Hold the stator against one side of the turbine wheel, and use a feeler gauge (43) to find the clearance between the stator and the turbine wheel.b. The clearance across the diameters between the stator and the turbine wheel must be 0.33 to 0.43 mm (0.013 to 0.017 in). Check the clearance at four points on the turbine wheel. The maximum permissible clearance across the diameters is 0.76 mm (0.030 in).c. The running clearance is one half of the clearance across the diameters between the stator and the turbine wheel. The running clearance must be 0.165 to 0.215 mm (0.0065 to 0.0085 in). The maximum permissible running clearance is 0.38 mm (0.015 in).2. Check the clearance between the impeller wheel and stator as follows: a. Use an outside diameter micrometer (44), and make a measurement of the diameter of the stator flange at four points on the stator. Make a record of the lowest reading. b. Use an inside diameter micrometer (45), and make a measurement of the inside diameter of the outer edge of the flange on impeller wheel (22) at four locations. Make a record of the highest reading.c. The clearance across the diameters between the impeller and stator is the difference between the highest reading on the impeller and the lowest reading on the stator. The clearance must be 0.25 to 0.35 mm (0.010 to 0.014 in). Maximum permissible clearance across the diameters if 0.61 mm (0.024 in).d. The running clearance is one half of the measurement made across the diameters. Running clearance must be 0.125 to 0.175 mm (0.005 to 0.007 in). Maximum permissible running clearance is 0.30 mm (0.012 in). 3. Use Tooling (F), and install bearing (42) into housing (34).4. Put retainer (41) in position on the housing, and install six bolts (46). Tighten bolts (46) to a torque of 50 7 N m (37 5 lb ft).5. Use Tooling (E), and install two bearings (38) in flange assembly (37). a. Outer bearing (38) should be installed to a depth of 25.4 mm (1.0 in) below the surface of flange assembly.b. Inner bearing (38) should be installed flush with the surface of flange assembly (37).c. Outer bearing (38) should have an inside diameter of 44.501 0.013 mm (1.7520 0.0005 in) after installation.6. If carrier (39) was removed from flange assembly (37), heat the carrier to a temperature of 138°C to 166°C (280°F to 330°F) for a maximum time of ten minutes. Install carrier (39) on flange assembly (37). Install seal ring (40) on the carrier.
When the flange assembly is installed into the housing, use care to avoid causing damage to seal ring (40).
7. Put SAE 30 oil on seal ring (40). Pull the ends