MODULE-CONTROL 1487413 - Caterpillar

Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 207-1601 Rubber Lubricant -
207-1600 Rubber Lubricant(1) -
(1) For use in EAME only
Hot engine components can cause injury from burns. Before performing maintenance on the engine, allow the engine and the components to cool.
Open the hood.
Illustration 1 g03352227
Disconnect sensor (1) and remove cable straps (2).
Illustration 2 g03352233
Disconnect harness assembly (3), harness assembly (4), hose assembly (5), and hose assemblies (7). Disconnect bracket (6).
Illustration 3 g03352248
Disconnect harness assembly (8) and cable straps (9).
Illustration 4 g03352257
Disconnect hose (10) and ball clamp assembly (11).
Illustration 5 g03352309
Disconnect hose assembly (12).
Illustration 6 g03352319
Attach suitable lifting device to clean emissions module (13). The weight of clean emissions module (13) is approximately 227 kg (500 lb).
Illustration 7 g03352331
Remove bolts (14). Remove clean emissions module (13). Installation Procedure
Install clean emissions module (13) in the reverse order of removal.
Apply Tooling (A) to the O-ring seal inside hose assembly (12).
Illustration 8 g03352669
Cutaway view of the ball clamp assembly.
Illustration 9 g03352673
Cutaway view of the ball clamp assembly.
Prior to installation, position ball clamp assembly (11).
Verify that the cup of the Ball Joint (C) does not touch the radius of the ball (B). Position ball clamp (11) and hand tighten ball clamp (11). Measure Dimension (Y) and Dimension (Z). Dimension (Y) and Dimension (Z) should be equal to each other. Repeat the measurements every 90° around ball clamp (11). If necessary, adjust ball clamp (11).
Tighten ball clamp assembly (11) to a torque of 35 2 N m (26 1 lb ft). Note: Do not use power tools in order to torque ball clamp assembly (11).