MODULE AS 1636088 - Caterpillar

Illustration 1 g01223034
Display for WAVS
Illustration 2 g01223051
Camera for WAVS
Illustration 3 g02513897The rear facing camera has been set by the factory or by a Cat dealer in order to provide the following view:
Partial view of the push block.
View of an object on the ground 2.1 m (6 ft 10 inch) behind the push block.
View of an object on the ground at a minimum 24 m (78 ft 9 inch) behind the push block.
If equipped, a portion of the radiator guard.
If equipped, a portion of the scraper hook.Note: Depending on your machine configuration, a partial view of the push block may not be attainable.
Illustration 4 g02513916
Top View of the Machine
Adjust the right side camera in order to provide visibility to the right side of the machine. Approximate camera view should be adjusted to view the areas shown in the shaded area.Consult your Cat dealer before any adjustments are made to the camera.Prior to operating the machine, ensure proper orientation of images by the cameras. The cameras have been set up by the factory or by a Cat dealer in order to provide views which comply with the guidelines that have been documented. Consult your Cat dealer before any adjustments are made to the cameras.Prior to operating the machine, ensure that the features of the display are properly adjusted. Ensure that the brightness and the contrast are adjusted prior to operating the machine. Ensure that the brightness and the contrast are adjusted after changes in the conditions for ambient light. Prior to operating the machine, ensure that the display is positioned in order to provide clear visibility of the display from the operator seat. Do not position the display in a way that will cause the following conditions:
Cover any safety messages or other important information.
Impede the entry to the cab or impede the exit from the cab.
Obstruct the visibility of the operator.
Obstruct the view of any indicators, gauges, or monitoring system.
Impair access to any operator controls or impair movement of any operator controls.Prior to operating the machine, ensure that the camera lens and the display are clean.Refer to Operation and Maintenance Manual, SEBU8157, "Work Area Vision System" for additional information about WAVS.