MODULE GP-MONITOR KEYPAD 1981402 - Caterpillar

Illustration 2 g01179388
Use the original mounting holes of the wiper motor in order to mount template (A) to the back of the cab.
Center punch the five mounting holes (G) for the new rear wiper group. Use a 10.5 mm (0.4135 inch) drill bit to drill the four holes in the cab.
Remove template (A) .
Illustration 3 g01179389
Install wiper motor (9). Torque the nut to 38 2 N m (335 18 lb in). Use one bolt (10) and one washer (11) to secure the wiper motor. Connect harness (18). The motor will go to the park position.Note: Complete the following steps prior to installing the cover assembly (6) on the cab.
Illustration 4 g01179390
Remove the rear cover (19) of the cover assembly (6) by removing four bolts (20) .
Illustration 5 g01179391
Install connector assembly (3A) and install connector assembly (3B) in the cover assembly (6). Position the elbow side of the connectors on the outside of the cover assembly. Refer to Illustration 5 for the orientation of the connectors.
Cut hose (17) into three pieces (17A), (17B), and (17C). Piece (17A) of the hose should be 130 5 mm (5.10 0.2 inch) long. Piece (17B) of the hose should be 50 5 mm (2.0 0.2 inch) long. The remaining piece of hose (17C) should be 580 10 mm (23 0.4 inch) long.
Illustration 6 g01179393
Connect hose (17C) to connector assembly (3B). Use three cable straps (1) to secure the hose to links (21) .
Connect tee (13) to the other end of hose (17C). Refer to Illustration 6 for the proper orientation of the tee.
Connect hose (17A) to connector (3A). Attach the other end of hose (17A) to tee (13). Refer to Illustration 6 for the proper orientation of the tee.
Connect hose (17B) to tee (13). Refer to Illustration 6 for the proper orientation of the tee.
Illustration 7 g01179394
(VIEW A) Complete cover assembly (VIEW B) The back plate of the cover assembly is not shown for illustration purposes.
Install wiper linkage group (7). Torque the nut to 38 2 N m (335 18 lb in).
Install wiper linkage group (8). Torque the nut to 38 2 N m (335 18 lb in).
Connect wiper linkage group (7) to wiper linkage group (8) at location (F). Refer to Illustration 7 for the proper orientation of the linkage.
Illustration 8 g01179395
Install cover assembly (6) on the back of the cab. Use four bolts (15), one bolt (12), five nuts (14), and ten washers (16) to secure the cover assembly.
Illustration 9 g01179396
Attach pivot (22) to the shaft of wiper motor (9). Torque the nut to 13.5 1.5 N m (120 13 lb in).ReferenceRefer to Illustration 9 for orientation of the pivot shaft.
Connect hose (17B) to the connector that is mounted in the cab.
Install blade assemblies (2) .
Illustration 10 g01157789
(B) The dimension for installing wiper arm (5) is 63 10 mm (2.50 0.40 inch). (C) The dimension for installing wiper arm (4) is 21 10 mm (0.80 0.40 inch).
Install wiper arm (4) and install