MODULE GP-WARNING INDICATOR 2492910 - Caterpillar

Status Groups for Cat ET
In order to access the status groups, follow the procedure that is listed below.
Select the "Information" tab on the menu bar in Cat ET.
Click "Status" or click the "Status" icon on the tool bar.The status groups should be used in order to verify that the installation of the PLE601 module has been successful. There are only four screens available in Cat ET for verifying and servicing the PLE601 system.Software installation
For procedure for installing software on to the PLE601 Network Manager ECM refer to Testing and Adjusting, UENR3697, "ECM Software - Install".Flash File and Configuration File part numbers are located at https://engines.cat.com/catconnect.Subscribing
The PLE601 Network Manager is configured automatically for the services selected in the web-based service management tool in Product Link Web. Your Caterpillar dealer administrator will be notified when your device is on-line and ready to have services enabled. Once the dealer selects the desired services, the configuration will be sent over the air and the device will be configured in order to provide the proper data at the proper frequency for the service in Product Link Web.Consult with your dealers Product Link specialist for additional details in assisting you for the right data service to meet your needs. Service starts with basic equipment management features providing hour, location monitoring, health, and utilization.Initial Setup
The Caterpillar dealer administrator
Log in to Product Link Web.
Select "Control Center" from the primary navigation bar.
Illustration 29 g03516217
Select "Services" from the secondary navigation bar. Refer to Illustration 29.
Search for the desired PLE640 installed equipment.
Confirm proper customer ownership.
Select the desired services. The services management system will configure the PLE640 per the subscription selected in this process.For more information refer to https://dealer.cat.com/PL locate Product Link Web for Power Systems and select "Module 6: Control Center".Note: The web site https://dealer.cat.com/PL will require a user name and password.General Installation Checklist
Note: – Ensure that power is disconnected from the equipment during installation of the PLE640 Product LinkTM system.
Find a suitable location for the installation of the Network Manager. Remember that the Network Manager must be installed within 1 m (3.2 ft) of the CAN datalink.
Find a suitable location for the installation of the Cellular Radio. The cellular radio needs to have clear line of site to the sky in order to relay accurate GPS information. For stationary units located in a building, the radio can be mounted without clear line of site to the sky, but may not report GPS location. Remember that the Cellular Radio must be installed within 100 m (328.0 ft) of the Network Manager.
Connect the retrofit harness to the Network Manager. Connect the open wires on the retrofit harness to your piece of equipment. Connecting the open wires can be done either by adding T connectors to your equipment, or by splicing into the appropriate wires. See Table 16 for information on the eight wires that must be connected to your equipment.
Connect the Cellular Radio to either Radio Interface 1, or Radio Interface 2 on the retrofit installation harness. If the radio is