MODULE AS-INLET 2909779 - Caterpillar

Illustration 17 g00630018
Install the bolt that holds clip (25) in place.
Illustration 18 g00630006
Connect the three wires to the electric starting motor. Install nut (24) .
Illustration 19 g00630004
Install the winch. Install three bolts (23) which hold the bracket for the winch.
Illustration 20 g00630009
Install pulley (22). Install bolt (21) .
Illustration 21 g00629996
Connect hose (20) to the water pump.
Install the bolt which holds clip (19) .
Illustration 22 g00629995
Install the bolt which holds clip (18) .
Illustration 23 g00630017
Install the bolt that holds clip (17) in place.
At the rear motor mount, tighten clamp (16). Connect hose (15) .
Illustration 24 g00630016
Connect hose assembly (14) .
Connect two electrical connectors (13) .
Illustration 25 g00629991
Connect breather hose (12) .
Install belt (11) .
Illustration 26 g00629989
Connect two electrical connectors (10) .
Illustration 27 g00630025
Place refrigerant compressor (8) in position. Install bolts (5) and (7), the washers and the nuts.
Install belt (9). Adjust the tension on belt (9) .Note: Check the fan belt tension. Use a Kent Moore Company BT-33-97 gauge. The correct tension for a new V-belt is 534 22 N (120 5 lb). The correct tension for a used V-belt is 400 44 N (90 10 lb). A used V-belt has been active over 30 minutes at rated speed.
Illustration 28 g00630021
Tighten bolt (5) .
Connect two electrical connectors (4) .
Illustration 29 g00629988
Install the bolt which holds clip (3) in place.
Connect electrical connector (2) .
Illustration 30 g00629987
Connect two fuel lines (1). ,,,, End By:
Install the machine preheater. Refer to Disassembly and AssemblyRENR3036, "Machine Preheater - Remove and Install".
Install the implement pump. Refer to Disassembly and Assembly, "Piston Pump (Implement) - Install".
Install the hydraulic oil tank. Refer to Disassembly and Assembly, "Hydraulic Tank - Install".
Install the muffler. Refer to Disassembly and AssemblyRENR3036, "Muffler - Remove and Install".
Install the radiator. Refer to Disassembly and AssemblyRENR3036, "Radiator - Install".
Install the air compressor. Refer to Disassembly and AssemblyRENR3036, "Air Compressor - Remove and Install".