MODULE GP-WARNING INDICATOR 3116609 - Caterpillar

Position support (36) for the hose clamp to the top of torque converter housing (6). Install bolt (35) and the washer that secures support (36) for the hose clamp to the top of torque converter housing (6) .
Illustration 66 g00604846
Connect hose assembly (34) to the check valve on the piston pump for the steering system.
Illustration 67 g00604845
Connect hose assembly (33) to the check valve on the piston pump for the steering system.
Illustration 68 g00604843
The location of the block is on the left side of the torque converter.
Connect block (31), the rectangular seal, and the hose assemblies to torque converter housing (6) .
Install four bolts (32) and the washers that secure block (31) and the rectangular seal to torque converter housing (6) .
Position clamp (30) and the hose assembly to block (31). Install bolt (29) in order to connect clamp (30) and the hose assembly to block (31) .
Illustration 69 g00604839
Position elbow (28) and the O-ring seal to torque converter housing (6). Install four bolts (27) and the washers that secure elbow (28) and the O-ring seal to torque converter housing (6) .
Position wire harness (22) to relief valve (26). Connect wire harness (22) at connector (24). Install connector (24) to clip assembly (25) .
Position wire harness (22) to torque converter oil temperature sender (23). Install the nut, the flat washer, and the star washer that secures wire harness (22) to torque converter oil temperature sender (23) .
Install two new tie straps (21) to wire harness (22) .
Illustration 70 g00604838
Connect hose assembly (20) to the bottom of the torque converter case.
Connect three hose assemblies (18), (17), and (16) to gear pump (19) for the power train.
Illustration 71 g00604836
The location of clamp (15) is near the diverter valve. Hose assembly (16) supplies oil to the gear pump for the power train.
Position clamp (15) to hose assembly (16). Install the bolt, the washers, the spacer, and the nut that secures clamp (15) to hose assembly (16) .
Illustration 72 g00604842
Connect wire harness (13) to speed sensor (14) .
Install swivel tee (11) to torque converter housing (6). Connect hose assembly (12) to swivel tee (11). Connect hose assembly (10) to swivel tee (11) .
Illustration 73 g00604841
Connect wiring harness (9) at the electrical connection. Connect wiring harness (8) at the electrical connection. Connect wiring harness (7) at the electrical connection.
Install bolt (5) that secures the harness clip to torque converter housing (6) .
Illustration 74 g00591860
The view is on the left side of the torque converter near the top of the torque converter.
Connect two hose assemblies (2) and (3) to torque converter priority valve (4) .
Illustration 75 g00583493
Install drain plug (1) to the torque converter. Check the oil level of the transmission oil. If necessary, fill the transmission oil.
Refer to Operation and Maintenance, "Transmission Oil Level - Check" for the appropriate procedure.
Refer to Operation and Maintenance, "Lubricant Viscosities" for the appropriate oil. The capacity of the power train system is 379 L (100 US gal).End By:
Install the hood for the engine. Refer to