MODULE GP-DISPLAY 3132154 - Caterpillar

Illustration 1 g00546877
Fuel Injection Control Linkage (1) Fuel control rod (2) Actuator shaft (3) Bellcrank (4) Rack (5) Control rod (6) Lever (7) Fuel control shaft (8) Control rod
Illustration 2 g00546866
Fuel Injection Control Linkage (1) Fuel control rod (5) Control rod (7) Fuel control shaft (8) Control rod
Illustration 3 g00681823
Fuel Injection ontrol Linkage (1) Fuel control rod. (2) Actuator shaft. (3) Bellcrank. (4) Rack. (5) Control rod. (6) Lever. (7) Fuel control shaft. (8) Control rod. (9) Cross shaft.A fuel injector is located in each cylinder head. The position of rack (4) controls the amount of fuel that is injected into the cylinder. Pull the rack out of the fuel injector for more fuel. Push the rack into the fuel injector for less fuel.The rack position is changed by bellcrank (3). The bellcrank is moved by control rod (8). The control rods have an adjustment screw on the top. The adjustment screw is used to synchronize the fuel injectors. The control rods are spring loaded. If one of the fuel injector racks is in a bind in the FUEL-ON position, it will still be possible for the governor to control the other racks. The other racks must be controlled by the governor so that the engine can be shut down, as required. If the rack is in a bind in the FUEL-OFF position, the engine will not start. Each control rod is connected by a lever (6) to control shaft (7). The two fuel control shafts on both sides of the engine are connected by the cross shaft (9) .Note: Directions of rotation are viewed from the flywheel end of the engine.If the linkage becomes disconnected from the governor, the weight of the control linkage will move the fuel injector racks to the FUEL-OFF position. When the fuel injector racks move to the FUEL-OFF position, the engine will stop.