MODULE GP-DISPLAY 3831210 - Caterpillar

Illustration 21 g01818069
Install block (5) with two bolts (R) .
Illustration 22 g01818114
Tighten bolts (R) to 12 3 N m (106 27 lb in).
Illustration 23 g01818135
Wrap tape (3) around the bottom of sleeve (2). Make sure that tape (3) covers the bottom of sleeve (2) and the exposed wiring.
Illustration 24 g01818174
Illustration 25 g01818396
(CC) Center of the breakout for the wire harness 365 mm (14.370 inch) (DD) 358.2 mm (14.102 inch)
Wrap tape (3) around sleeve (2) to location (DD) of the connector for the parking brake that protrudes from sleeve (CC). Refer to Illustration 23 and Illustration 24.
Illustration 26 g01818494
Route the wiring for the handle assembly to chain link (EE) that is below the steering sensor.
Secure the wiring in location (CC) to chain link (EE) with cable strap (6) .
Illustration 27 g01946310
Secure the end of the wire harness with the three connectors to clip (FF) .
Illustration 28 g01818558
Illustration 29 g01818962
Place cable strap (6A) through the center hole of clip (FF, ) and back through the bottom hole of clip (FF). Secure the two 6-pin connectors.
Place cable strap (6B) through the center hole of clip (FF), and then around the 4-pin connector, and then to the lower hole of clip (FF) .
Install harness (7) to the console.
Illustration 30 g01820057
Connect the plug for the shift Up and Down that has Pin 1 green wire (GG) and Pin 3 yellow wire (HH) to the corresponding plug on the wiring harness for the console that has Pin 1 green wire and Pin 3 yellow wire.
Illustration 31 g01820058
Connect the plug for the shift Forward and Reverse that has Pin 2 blue wire (JJ) and Pin 5 orange wire (KK) to the corresponding plug on the wiring harness for the console that has Pin 2 blue wire and Pin 5 orange wire.
Illustration 32 g01820162
Connect the plug for the "FNR" sensor that has Pin 1 white wire (MM), Pin 2 black wire (NN), and Pin 3 white wire (PP) to the corresponding plug on the wiring harness for the console that has Pin 1 white wire, Pin 2 black wire, and pin 3 white wire.
Illustration 33 g01820234
Connect the remaining plugs, the 8 Pin plug to the parking brake and the 12 Pin plug to the steering sensor. Refer to Illustration 33.
Install the hardware and trim that was removed in disassembly. Reinstall the control group into the machine.
The "FNR" sensor and the steering sensor may need to be calibrated.