MODULE GP-KEYPAD 4603179 - Caterpillar

Improper lifting and improper tie-downs can allow the load to shift or fail and cause injury or damage. Use only properly rated cables and slings with lift and tie down points provided.Follow the instructions in Operation and Maintenance Manual, "Lifting and Tying Down the Machine" for the proper technique for securing the machine. Refer to Operation and Maintenance Manual, "Specifications" for specific weight information.
Illustration 1 g03795322
Illustration 2 g06172041
814K machine locations of lifting and tie-down points.
(1) Rear lifting and tie down points
(2) Front lifting and tie down points
Improper lifting or tie-downs can allow the load to shift and cause injury or damage. Install the steering frame lock link before lifting.
Note: Do not use handles or steps to lift or tie down the machine.Note: The machine shipping weight that is listed is the weight of the most common configuration of the machine. If attachments have been installed on your machine, the weight of your machine and the center of gravity of your machine may vary.Reference: Refer to Operation and Maintenance Manual, "Specifications" for the dimensions and weight of the machine.
Lifting Point - To lift the machine, attach the lifting devices to the lifting points.
Tie Down Point - To tie down the machine, attach the tie-downs to the tie-down points.Use properly rated cables and properly rated slings to lift the machine.Position the crane or the lifting device to lift the machine in a level position.The width of the spreader bar must be sufficient to prevent the lifting cables or the lifting straps from contacting the machine.
Engage the parking brake before you sling the machine and before you secure the machine with tie-downs.
Install the steering frame lock link prior to lifting the machine.
Attach two lifting cables to the rear of the machine. There is one lifting and tie-down point on each side of the rear of the machine. The lifting and tie-down points are identified by a film.
Connect the lifting cables at the rear of the machine to a spreader bar. The spreader bar must be centered over the machine.
Attach two lifting cables to the front of the machine. There are two lifting points at the front of the machine forward of the front axle. The lifting points are identified by a film.
Connect the lifting cables at the front of the machine to a spreader bar. The spreader bar must be centered over the machine.
If equipped, secure any attachments.
Lift the machine. Move the machine to the desired position.
When the machine is positioned, place blocks behind the wheels.
Secure the front of the machine at the tie-down points. The tie-down points for the front of this machine are the same as the lifting points for the front of this machine. The points are identified on the machine by a film. There is one tie-down point on each side of the front of the machine forward of the front axle.
Secure the rear of the machine at the tie-down points. The tie-down points for the