MODULE-IGNITION 5542746 - Caterpillar

Batteries
Check the Electrolyte Level
Batteries give off flammable fumes that can explode resulting in personal injury.Do not smoke when observing the battery electrolyte levels.Electrolyte is an acid and can cause personal injury if it contacts skin or eyes.Always wear protective glasses when working with batteries.
Check the batteries more often when working in extreme heat situations.If an addition of water is necessary, use distilled water. If distilled water is not available, use clean water that is low in minerals. Do not use artifically softened water.At the proper charging rate, batteries should not require more than 30 cc (1 ounce) of water per cell per week. 1. Unlatch and raise the battery compartment cover. Located on the right side of the machine. 2. Clean the tops of the batteries with a clean cloth. Check the cable clamps and terminals for corrosion or looseness. If necessary, clean, tighten or replace the cable clamps.Clean the cable clamps and the terminals with a wire brush, if corroded. Coat the terminals with petroleum jelly. 3. Remove the fill caps. Maintain the electrolyte level to the bottom of the fill plug openings. Install the plugs.Fuel Filter - Deutz Engine
Drain and Clean Fuel Bowl
Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire.Turn the key start switch OFF or disconnect the battery when changing fuel filter.
Do not fill fuel filters with fuel before installing them. Contaminated fuel will cause accelerated wear to fuel system parts.
Open the engine access door. 1. Clean around the fuel filter.2. Loosen the knurled nut and move the retainer back.3. Remove the glass bowl and empty.4. Install the glass bowl.5. Move the retainer under the glass bowl and tighten the nut.6. Close the access door.Steering Axle
Lubricate the Fittings
Fittings located behind the front tires. Lubricate the four fittings behind each steering tire.Total of eight fittings.Oscillating Axle Pins
Lubricate the Fittings
Fittings located on the front of the machine. Lubricate the two fittings.Swing Bearing
Lubricate Gear Teeth and Fittings
Gears located under the upper structure. Fittings located under the boom. Apply grease to the gear teeth. Lubricate the two fittings.Universal Joints - Drive Shaft
Lubricate the Fittings
Fitting located below the center of the machine. Lubricate the four fittings.Dozer Blade
Lubricate the Fittings
Lubricate the twelve fittings.