MODULE-CONTROL 7C2700 - Caterpillar

Removal Procedure
Start By:
Remove the flywheel. Refer to Disassembly and Assembly, " Flywheel - Remove".
Support the engine with blocks or a suitable lifting device.
Illustration 1 g01011078
Remove bolts (1).
Remove flywheel housing (2). The weight of the flywheel housing is approximately 23 kg (50 lb).
Illustration 2 g01011079
Remove O-ring seal (3) from rear seal carrier (4). Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1U-6396 O-Ring Assembly Compound 1
B 1U-8846 Gasket Sealant 1
Illustration 3 g01011079
Apply Tooling (A) to O-ring seal (4). Install O-ring seal (3) onto rear seal carrier (4).
Apply Tooling (B) to the face of the cylinder block.
Illustration 4 g01011078
Position flywheel housing (2) on the rear of the cylinder block. The weight of flywheel housing (2) is approximately 23 kg (50 lb).
Install bolts (1). End By:
Install the flywheel. Refer to Disassembly and Assembly, " Flywheel - Install".