MOLDBOARD AS 3202746 - Caterpillar

Assembly Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
B     1P-0510     Driver Group     1    
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01072202
Use Tooling (B) to install seal (11) into housing (1). Ensure that the lip of seal (11) is toward the outside. Install seal (11) .
Illustration 2 g01072200
Install shaft assembly (5) into housing (1) .
Install washer (7) into housing (1) .
Install O-ring seal (8) into housing (1) .
Illustration 3 g01072124
Install the rubber ring and ceramic seal (10) into housing (1) .
Illustration 4 g01072122
Install seal assembly (9) into housing (1) .
Illustration 5 g01072118
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install spring (6) onto shaft assembly (5) in housing (1) .
Illustration 6 g01072183
Install impeller (4) onto shaft assembly (5) in housing (1). Use a suitable press to install impeller (4) onto shaft assembly (5) .
Dimension (AA) should measure 31.58 0.44 mm (1.243 0.017 inch).
Illustration 7 g01072114
Install the O-ring seal and cover (3) into housing (1). Install nuts (2) onto cover (3). Tighten nuts (2) to a torque of 27 4 N m (20 3 lb ft).End By: Install the water pump. Refer to Disassembly and Assembly, "Water Pump - Install".