MONITOR GP- 1723989 - Caterpillar

1. Drain engine oil-capacity 15 U.S. Gal. (57 liter).2. Remove crankcase guards. 3. Separate steering follow-up link mounting bracket (1) from frame. 4. Remove follow-up bracket (2) from steering arm.5. Remove lines (3) and (4) from head-end of steering cylinders. 6. Remove bolts (5) and kidney shaped retaining key from steering arm. 7. Install tool (A) and push pin from steering arm. 8. Attach ratchet assembly, tool (B), and pull steering arm away from frame. Release cable and allow arm to drop about 6 in. (15 cm). 9. Loosen oil pan retaining bolts and remove front section (6) of oil pan. 10. Remove filler tube (7) from side of oil pan. 11. Remove remaining pan bolts and remove oil pan.Install Oil Pan
1. Position oil pan, under engine, on frame crossmember.2. Connect front and rear pan sections. Pay careful attention to O-ring position.3. Install oil pan gasket on pan.4. Raise pan into position and install mounting bolts. 5. Connect oil filler tube (7) to side of pan. 6. Position steering arm near pin boss on frame and install pin retainer (8) with one bolt.7. Install pin through arm and frame. Slot in pin must align with pin retainer. 8. After pin retainer drops into slot in pin, install remaining bolt (5). 9. Connect steering cylinder hydraulic lines (3) and (4) and attach follow-up link (2) to steering arm. 10. Connect follow-up link (1) to frame.