MONITOR & MTG GP-OPERATOR 1873770 - Caterpillar

Table 1
Switch Circuits at the ECM Connector
CID
Switch Switch
State ECM
Connector
Contact Switch
Connector
Contact Wire Status
CID 0622
Upshift
Switch Deactivated J1-30 N/O N/O(1) F785-WH(White) O(2)
J1-24 N/C N/C(3) F783-GN(Green) G(4)
Activated J1-30 N/O N/O F785-WH(White) G
J1-24 N/C N/C F783-GN(Green) O
(1) "N/O" is Normally Open.
(2) "O" is Open.
(3) "N/C" is Normally Closed.
(4) "G" is Grounded.When the transmission fails to upshift, the transmission gear that is displayed by the Caterpillar Monitoring System does not change. The upshift switch is a push button switch. The switch has two inputs to the ECM. During normal operation, one input is open and one input is closed to ground. This failure can occur when both inputs are in the same state and the switch is activated. Other possible causes are listed below:
The gear that is desired has been locked out.
Diagnostic codes are causing additional failures.
There is a open wire between the normally open contact of the switch and the ECM.
There is a grounded wire between the normally closed contact of the switch and the ECM.
The switch has failed.
The ECM has failed. This is unlikely.Note: The symptoms for CID 0622 FMI 02 are similar.Test Step 1. CHECK THE STATUS OF THE GEAR LOCKOUT.View the status of the gear lockout (forward) and the gear lockout (reverse). See Testing and Adjusting, "Calibration - Submode 20 - Set Forward High Speed Lockout". See Testing and Adjusting, "Calibration - Submode 21 - Set Reverse High Speed Lockout".Expected Result:Third gear was locked out in forward or reverse.Results:
YES - Third gear was locked out in forward or reverse.Repair: Set the highest gear to the desired value.STOP
NO - Third gear was not locked out in forward or reverse. Proceed to Test Step 2.Test Step 2. CHECK FOR DIAGNOSTIC CODES.View the logged diagnostic codes.Expected Result:Diagnostic codes are active.Results:
YES - Diagnostic codes are active.Repair: Exit this test procedure and perform the diagnostic code procedures. Operate the machine and verify that the problem has been repaired.STOP
NO - No diagnostic codes are active. Proceed to Test Step 3.Test Step 3. CHECK THE CIRCUIT FOR PROPER OPERATION.
Turn the key start switch to the ON position.
Access the "Component Data Display Mode". View the value that is displayed for CID 0622. There are values for the normally open circuit and the normally closed circuit. See Testing and Adjusting, "Calibration" for a list of the values that are visible.
Press the upshift switch with the lever in the forward position. Press the upshift switch with the lever in the reverse position. Expected Result:The value that is displayed changes from "OC" to "CO".Results:
OK - The value that is displayed changes from "OC" to "CO". Proceed to Test Step 4.
NOT OK - The value that is displayed does not change from "OC" to "CO".Repair: The normally open circuit or the normally closed circuit has failed. Exit this procedure. Perform the procedure for CID 0622 FMI 02. Operate the machine and verify that the problem has been repaired.STOPTest Step 4. CHECK THE OPERATION OF THE TRANSMISSION SHIFT LEVER.
Operate the machine.
Press and release the upshift switch. Press and release the downshift switch. Expected Result:The transmission operates properly.Results:
OK