MONITOR AS- 2938413 - Caterpillar

Table 1
Specification for 352-7143 Check and Relief Valve Gp
Item Qty Part Specification Description
1 4 225-4818 Plug As Torque to 10 1 N m (89 18lb in).
2 9 5M-9624 Shim As required, use to adjust the pilot pressure so that the cylinder flow starts to pass through the control valve
Thickness is 0.25 mm (0.010 inch).
3 9 6J-6855 Shim As required, use to adjust the required distance (C):
Thickness is 0.12 mm (0.005 inch).
C - - Distance between the guide and the piston is 7.75 0.10 mm (0.305 0.004 inch).
4 1 203-2076 Spring Length under test force is 51.3 mm (2.02 inch).
Test force is 206.64 20.00 N (46.45 4.50 lb).
Free length after test is 55.58 mm (2.188 inch).
5 1 293-0653 Guide Torque to 35 4 N m (26 3 lb ft).
6 4 225-4820 Plug As Torque to 23 2 N m (204 18 lb in).
7 1 222-3347 Flow Control Valve Gp Torque to 215 25 N m (156 18 lb ft).
8 1 2S-2596 Spring Length under test force is 7.9 mm (0.31 inch).
Test force is 4.0 0.5 N (0.9 0.1 lb).
Free length after test is 33.3 mm (1.31 inch).
9 1 270-5731 Relief Valve Gp Torque to 95 14 N m (70 10 lb ft).
10 1 8J-6815 Orifice Plug Torque to 13 2 N m (115 18 lb in). Assembly Procedure
Illustration 2 g02422016
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Install the O-ring seals, plug (28), and plugs (29). Tighten plugs (29) to