MONITOR GP-OPERATOR 3689117 - Caterpillar

Lift Kickout
Note: The bucket must be above the midway point in order to set the lift kickout position. The bucket must be below the midway point in order to set the lower kickout position.
Illustration 1 g00292579
Start the engine and raise the bucket to the desired height. Push the lift kickout switch in order to adjust the lift kickout to the desired height.
Lower the bucket to the desired height. Push the lower kickout switch in order to adjust the lower kickout to the desired height.
To check the adjustment of the lift kickout, move the lift control lever to the RAISE detent position.When the bucket reaches the preset height, the lift control lever should return to the HOLD position.
To check the adjustment of the lower kickout, move the lift control lever to the LOWER detent position.When the bucket reaches the preset height, the lift control lever should return to the HOLD position.
The position sensor detects the position of the lift arm and that information is sent back to the control module. If the Kickout position is incorrect, the Rotary Position Sensor may require adjustment.Reference: Refer to Testing and Adjusting, "Position Sensor (Lift Linkage) - Adjust" for additional information on adjusting the Position Sensor.