MONITOR GP-OPERATOR 3T9200 - Caterpillar

Warning Signs and Labels
There are several specific safety signs on your generator. Their exact location and description of the hazard are reviewed in this section. Please take the time to familiarize yourself with these safety signs.Make sure that you can read all safety signs. Clean and replace these if you cannot read the words or see the pictures. When cleaning the labels use a cloth, water and soap. Do not use solvent, gasoline, etc.You must replace a label if it is damaged, missing or cannot be read. If a label is on a part that is replaced, make sure a new label is installed on the replaced part. See your Caterpillar dealer for new labels.
Do not operate this equipment unless you have read and understand the instructions in the Operation Guide. Improper operation is dangerous and could result in injury or death. Contact any Caterpillar dealer for a replacement guide. Proper operation is your responsibility.
If this generator is to be connected to a utility electrical distribution system, it must be isolated from the distribution system by means of;A. Opening the main switch in the case of a portable generator temporarily connected to the system or,B. A double throw (transfer) switch in the case of a permanent connection to the system.Failure to do so could result in personal injury or death due to electrical shock.The above warning does not apply when a generator and utility distribution system are designed and approved by the utility to run in parallel.
Installation
All electrical equipment supplied by Caterpillar should be installed in accordance with the Application and Installation Manual, form LEBX6213 and conform to national and local electrical codes of the area and county where the equipment is operating.General
Do not allow unauthorized or untrained personnel on or near equipment.Do not wear loose clothing or jewelry while working around equipment.Stop the engine before making adjustments or repairs to the engine or generator unless otherwise specified.Attach a "DO NOT OPERATE" tag on the start switch, start button, air start knob and/or remote starting system, before servicing the engine or generator. These tags, Form SEHS7332, are available from your Caterpillar dealer.Be sure the remote starting system is inoperative on the equipment being serviced.Disconnect and tape the battery ground lead or put the automatic start-stop switch to the STOP position before working on the equipment to prevent accidental starting.To prevent injury, install guards over all exposed drive shafts, pulleys and any application with exposed rotating parts.Always use tools that are in good condition and be sure you understand how to use them before performing any service work. Remove all tools, electrical cords and any other loose items from the engine before starting.Engine speeds, temperatures and load are the best indications of performance. Rely on your instruments, record and compare readings to detect developing abnormalities.Wear a hard hat, face shield, clothing, shoes, respirator or other protective items when necessary.When using pressure air, always use approved safety equipment.Wear ear protective devices to prevent hearing damage, if working inside an enclosed