MOTOR GP-SWING 0874824 - Caterpillar

Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g03882483
Illustration 2 g03880782
Install the No. 7 camshaft bearing (rear), as follows:
Insert the large end of Tooling (B) into the No. 7 camshaft bore.
Position Tooling (D) on Tooling (A). Install Tooling (A) in Tooling (B).
Position camshaft bearing (1) on Tooling (B). Install Tooling (F) and Tooling (E) on Tooling (B).
Illustration 3 g03883563
Illustration 4 g03883585
Orientate camshaft bearing joint (2) to Dimension (B). Dimension (B) is 20 5 degree angle above horizontal.
Refer to Illustration 4 for the correct location of oil holes (3) in camshaft bearing (1). All seven camshaft bearings (1) have the same angle.
Illustration 5 g02548921
Use Tooling (A) through Tooling (F) to pull camshaft bearing (1) into the camshaft bore. Measure the depth of the camshaft bearings from the front face of the cylinder head to the distances listed in Table 2.
Table 2
Installation Depth of Camshaft Bearing
Dimension (D) 8.0 0.5 mm (0.31 0.02 inch)
Dimension (E) 178.1 0.5 mm (7.01 0.02 inch)
Dimension (F) 349.5 0.5 mm (13.76 0.02 inch)
Dimension (G) 521.0 0.5 mm (20.51 0.02 inch)
Dimension (H) 692.4 0.5 mm (27.26 0.02 inch)
Dimension (J) 863.8 0.5 mm (34.01 0.02 inch)
Dimension (K) 1035.3 0.5 mm (40.76 0.02 inch)
Illustration 6 g03882483
Illustration 7 g03882847
Install the No. 6 through No. 2 camshaft bearings, as follows:
Insert the large end of Tooling (B) into the camshaft bore.Note: Use Tooling (C) to align Tooling (A) and Tooling (B) with the camshaft bearing bores. Install Tooling (C) in the inside diameter of any installed camshaft bearing between Tooling (A) and Tooling (B).
Install Tooling (A) in Tooling (B). Position camshaft bearing (1) on Tooling (B). Install Tooling (F) and Tooling (E) on Tooling (B).
Refer to Step 1.d through Step 1.f for the correct orientation and proper installation depth of camshaft bearing (1).
Use Tooling (A) to pull camshaft bearing (1) into the camshaft bore.
Illustration 8 g03882483
Illustration 9 g03882848
Install the No. 1 camshaft bearing (front), as follows:
Insert the large end of Tooling (B) into the No. 1 camshaft bore. Assemble Tooling (A) and Tooling (C) on Tooling (B).
Position camshaft bearing (1) on Tooling (B). Install Tooling (F) and Tooling (E) on Tooling (B).
Refer to Step 1.d through Step 1.f for the correct orientation and proper installation depth of camshaft bearing (1).
Use Tooling (A) to pull camshaft bearing (1) into the No. 1 camshaft bore.End By:
Install the camshaft. Refer to Disassembly and Assembly, "Camshaft - Install".