MOTOR GP-AIR STG 0R9852 - Caterpillar

Illustration 5 g00275736
Install adjuster (37) and retainer clip (39) on cable (38). Install retainer clip (39) and cable (38) as a unit on the spring lever.
Illustration 6 g00275695
Install pin (36) and retainer clip (35) on each end of adjuster (37).
Illustration 7 g00275694
Install seat cushion tilt shaft (31) on the seat pan assembly. Slide spring (30) onto the seat cushion tilt shaft. Install two pins (34) in seat cushion tilt shaft (31). Install pin (32) in seat cushion tilt knob (33).
Illustration 8 g00275693
Install spring (28), fore and aft adjustment shaft (27), and bracket (24) on the seat pan assembly. Install three pins (23) in fore and aft adjustment shaft (27). Install fore and aft adjustment knob (26). Install pin (25) in fore and aft adjustment knob (26).
Install seat pan assembly (9) and the seat backrest on upper slide plate (29). Install two bolts (21) and the locknuts on the brackets on both sides of the seat. Install seven bolts (22) on the seat pan assembly.
Illustration 9 g00275692
Install shaft (20). Slide spring (19) onto shaft (20). Install two pins (16) in shaft (20). Install seat back adjustment knob (17). Install pin (18) in seat back adjustment knob (17).
Illustration 10 g00275691
Install seat belt retractor (14). Install the bolt that holds seat belt retractor (14) to the seat. Install comfort ride sleeve (13). Install the nut and bolt (15) that holds comfort ride sleeve (13) to the seat.
Illustration 11 g00275690
Install two springs (12) on seat pan assembly (9).
Illustration 12 g00275689
There is spring force against the seat lift plate when the seat lift plate is being installed.To prevent personal injury, retain the seat lift plate by hand during installation.
Pull up on seat cushion tilt lever (11) and install seat lift plate (10). While you hold down seat lift plate (10), install two cotter pins (8). Install the bottom seat cushion on seat pan assembly (9).
Illustration 13 g00275688
Install two cams, the adjustment rod, two spacer blocks (7) and two pins (6) on the seat backrest. Install lumbar plate (4) on the seat backrest and install rivets (5).
Illustration 14 g00287944
Install seat cushion (3) on the seat backrest.
Install two bushings (2) on the seat assembly. Turn each bushing clockwise by 1/4 of a turn in order to install the bushings.
Illustration 15 g00275631
Install back extension (1) on the seat assembly. The back extension is a slip fit.
Illustration 16 g00713003
Adjust the cable to the proper position after the seat has been assembled. Use the adjuster (17) in order to adjust the cable. The cable should not be tight. A small amount of slack should be present in the cable. The cable should move slightly before the seat will recline.
Install the contour series seat in the machine.