MOTOR GP-ELEC 10R3190 - Caterpillar

TECHNICAL INFORMATION BULLETIN JULY 21, 2004
MINI HYDRAULIC EXCAVATOR 301.5 (3YW4174-Up)
301.6 (BDH1022-Up)
301.8 (BFA2883-Up)
Component Code(s) 6502 6129SUBJECT: Interference Between Quick Coupler and Stick on Mini Hydraulic Excavators
PROBLEM:
Figure 1: Dump Position
Figure 2: Rack-back position
Interference may occur between the work tool?s quick coupler and the stick. The interference occurs when the attachment is in the full dump or rack-back positions. Refer to Figures 1 and 2.
SOLUTION:
Figure 3: Underside of stick
Figure 4: Top of stick
If interference occurs, grind the contact area of the stick until clearance is achieved. Figures 3 and 4 show the effected areas. Care should be taken not to remove any weld from these areas.
Grind a maximum of 12mm from both sides of the stick. Do not grind on the pin boss.
Grind a maximum of 12mm from both sides of the stick.
Grind a maximum of 25mm from both sides of the stick.
Grind a maximum of 3mm from both sides of the stick as is necessary. Maintain a 45? angle.
Paint the reworked area.
COPYRIGHT 2004 CATERPILLAR
ALL RIGHTS RESERVED