MOTOR GP-HYD 10R8710 - Caterpillar

Above 60° F (16° C)
Move governor control to just past detent positionSwitch to START Switch to OFF when engine starts32° to 60° F (0° to 16° C)
Switch to HEAT for indicated time Switch to START * Switch to OFF when engine startsBelow 32° F (0° C)
Move governor control to just past detent position Switch to HEAT for indicated time Switch to START *Use ether if required ***If engine does not start after 10 seconds, switch to HEAT for 30 seconds then back to start. If engine does not start this time, let starter cool 2 minutes, then repeat starting procedure.**Use ether sparingly. Follow manufacturers instructions carefully. Switch to OFF when engine startsNEVER switch to HEAT when engine is warm or running.Gasoline Engine Starting (12 Volt - In Seat)
Governor control OFF Compression release at START Pull OUT choke Throttle at 1/4-1/2 OPEN fuel valve Switch to START Switch to RUN when engine starts As engine warms push IN choke Throttle to HIGH IDLE when engine runs smoothly ENGAGE starting engine pinion ENGAGE starting engine clutch Compression release to RUN Move governor control to OPEN fuel injection pumps Throttle at 1/4-1/2 CLOSE fuel valve Push IN throttle when starting engine stops Switch to OFF DO NOT move clutch and pinion control while diesel engine is operating. Gasoline Engine Starting (Manual)
Governor control OFF Compression release at START Pull OUT choke Throttle at 1/4-1/2 OPEN fuel valve Magneto switch ON PULL recoil starter handle Let cable rewind SLOWLY As engine warms up push IN choke Throttle to HIGH IDLE when engine runs smoothly ENGAGE starting engine pinion ENGAGE starting engine clutch Compression release to RUN Move governor control to OPEN fuel injection pumps Throttle at 1/4-1/2 CLOSE fuel valve Push IN throttle when starting engine stops Magneto switch OFF DO NOT move clutch and pinion control while diesel engine is operating