MOTOR GP-WINDOW WIPER 1477973 - Caterpillar

Illustration 1 g00854143 (1) Plug Remove the plug in order to prime the pump. (2) Plug The plug is installed in the water inlet to the pump. The zinc rod and the plug are installed in the water outlet at this location. Assemble the zinc rod in the plug according to the following procedure.
Put 9S-3263 Thread Lock Compound on the shoulder of the rod. Do not put the sealant on the threads of the rod.
Tighten the rod. Torque ... 7 3 N m (62 26 lb in) (3) Seal Apply clean engine oil on the lip of the seal. Install the seal as the seal is shown. (4) Collar Apply 4C-9507 Retaining Compound between the shaft and the collar. (5) O-ring seal Apply clean engine oil to the seal prior to assembly. (6) O-ring seal Apply clean engine oil to the seal prior to assembly. (7) Nut Torque ... 135 to 200 N m (100 to 148 lb ft) (8) O-ring seals Apply clean engine oil on the lip of the seal prior to assembly. (9) Nut Apply 7M-7456 Compound to the threads of the nut. If the cotter pin cannot be installed, turn the nut clockwise until the nearest slot in the nut is in alignment with the hole in the shaft. Torque ... 135 to 175 N m (100 to 129 lb ft) (10) Shims Install the shims in order to get the following clearance between the port plate and the impeller. ... 0.18 to 0.23 mm (0.007 to 0.009 inch)
Table 1
Shim Table
Shim Thickness
5N-9015 Shim 0.38 mm (0.015 inch)
5N-9016 Shim 0.25 mm (0.010 inch) (11) Ring and water seal
Put clean water on the seal and the ring.
Use hand pressure in order to install the seal assembly on the shaft. Press the seal until the carbon face of the seal assembly makes contact with the shiny face of the ceramic seal. (12) Seal assembly
Put clean water inside the seal assembly.
Use hand pressure in order to install the seal assembly on the shaft. Press the seal until the carbon face of the seal assembly makes contact with the shiny face of the ceramic seal.