MOTOR GP-SWING 1527374 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Turn the battery disconnect switch to the OFF position.
Illustration 1 g03383021
Remove nut (3) from busbar (2).
Disconnect wire (4) from busbar (2).
Remove nuts (1) that secure busbar (2) to the glow plugs.
Remove busbar (1) from the glow plugs.
Illustration 2 g03383023
Clean the area around glow plugs (5). Ensure that the area is free from contamination before removal of the glow plugs.
Remove glow plugs (5) from cylinder head (6). Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 247-5377 Torque Wrench 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 3 g03383023
Before installing glow plugs (5), ensure that the glow plugs are operating correctly. Ref to Trouble Shooting, "Glow Plug Starting Aid - Test" “Check the Operation of the Glow Plugs” for the correct procedure.
Ensure that the threads of the glow plugs are clean and free from damage. Replace any damaged glow plugs.
Install glow plugs (5) into cylinder head (6). Tighten the glow plugs to a torque of 15 N m (132 lb in).
Illustration 4 g03383021
Illustration 5 g03383025
Position busbar (2) onto the glow plugs. Install nuts (1) onto the glow plugs.
Use Tooling (A) to tighten nuts (1) to a torque of 2 N m (17 lb in).
Connect wire (4) to the stud on busbar (2).
Install nut (3) to the stud on busbar (2). Tighten the nut to a torque of 6 N m (53 lb in). Ensure that wire (4) is correctly positioned at 30 degrees prior to tightening the nut (3).
Turn the battery disconnect switch to the ON position.