MOTOR GP-PISTON 1684612 - Caterpillar

Illustration 25 g00443313
Install retaining ring (22) onto stator carrier (20).
Illustration 26 g00443307
Install two O-ring seals (21) onto stator carrier (20).
Illustration 27 g00443304
Install stator carrier (20) into torque converter (12).
Illustration 28 g00447804
Install bearing (19) onto shaft (16).
Illustration 29 g00441769
Install retaining ring (18) onto shaft (16).
Illustration 30 g00441763
Install two O-ring seals (17) onto shaft (16).
Illustration 31 g00441583
Install shaft (16) into torque converter (12).
Illustration 32 g00441527
Install seal (15) onto shaft (16).
Illustration 33 g00441450
Place a piece of solder between shaft (16) and retainer (14). Install bolts (13). Tighten bolts (13) to a torque of 10 N m (88 lb in).
Remove bolts (13) and retainer (14). Measure the piece of solder and subtract 0.025 mm (0.001 inch) to 0.076 mm (0.003 inch) from the measurement to get the correct number of shims.
Install the correct number of shims (not shown), retainer (14), and bolts (13) onto torque converter (12).
Tighten bolts (13) to a final torque of 50 7 N m (37 5 lb ft).
Illustration 34 g00441305
Position cover (11) and install eight bolts (10).
Illustration 35 g00441172
Use Tooling (A), a hoist, and an appropriate lifting device to position housing (8) onto the torque converter. The housing weighs approximately 140 kg (308 lb).
Illustration 36 g00447913
Use Tool (B) and install lip type seal (9) in carrier (6).
Illustration 37 g00440546
Position carrier (6) onto the housing and install eight bolts (5). Tighten the bolts to a torque of 50 7 N m (37 5 lb ft).
Illustration 38 g00440545
Install the seal, yoke (3), retainer (2) and bolt (1) onto shaft (4). Tighten bolt (1) to a torque of 120 15 N m (89 11 lb ft).End By:
Install the torque converter. Refer to Disassembly and Assembly, "Torque Converter - Install"
. The information is in this manual.