MOTOR GP-SWING 1911385 - Caterpillar

1911385 MOTOR GP-SWING Caterpillar parts 304, 305

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA1911385
191-1385
1911385

Weight: 83 pounds 37 kg.

Buy MOTOR GP-SWING 1911385 Caterpillar genuine, new aftermarket tractor parts with delivery
MINI HYD EXCAVATOR,

This part in 3 request: Show. This information for suppliers only!

#1427202 1911385

2024-09-19

#642462 1911385

2021-04-28

#22161 1911385

2016-09-23

Compatible equipment models: 1911385:

MINI HYD EXCAVATOR 304 305 Caterpillar

Number on catalog scheme: 1

Caterpillar 1911385 Parts scheme MOTOR GP-SWING

For full view, you need register

Information:

Breathing ether vapors or repeated contact of ether with skin can cause personal injury. Personal injury may occur from failure to adhere to the following procedures.Use ether only in well ventilated areas.Do not smoke while changing ether cylinders.Use ether with care to avoid fires.Do not store replacement ether cylinders in living areas or in the operator's compartment.Do not store ether cylinders in direct sunlight or at temperatures above 49 °C (120 °F).Discard cylinders in a safe place. Do not puncture or burn cylinders.Keep ether cylinders out of the reach of unauthorized personnel.To avoid possible injury, be sure the brakes are applied and all controls are in Hold or Neutral when starting the engine.
Test Step 1. Inspect the Electrical Connectors and the Wiring
Remove electrical power from the ECM.
Thoroughly inspect the ECM connectors. Inspect any other connectors that are associated with the circuit. Refer to Troubleshooting, "Electrical Connectors - Inspect".
Perform a 45 N (10 lb) pull test on each of the wires that are associated with the ether injection system.
Check the torque of the allen head screws for the ECM connectors. Refer to Troubleshooting, "Electrical Connectors - Inspect" for the correct torque values.
Check the harness and the wiring for abrasion and for pinch points from the ether injection solenoid to the ECM. Expected Result:All connectors, pins, and sockets are completely coupled and/or inserted, and the harness and wiring are free of corrosion, of abrasion and of pinch points.Results:
OK - The connectors and the wiring appear to be OK. Proceed to Test Step 2.
Not OK - The connectors and/or the wiring are not OK.Repair: Repair the connectors and/or the wiring. Replace parts, if necessary. If necessary, use the electronic service tool to perform a "Wiggle Test".Use the electronic service tool in order to clear all logged diagnostic codes and then verify that the repair eliminates the fault.STOPTest Step 2. Check for Active Diagnostic CodesNote: Remove the ether canister before you perform this procedure.
Connect the electronic service tool to the diagnostic connector. Refer to Troubleshooting, "Electronic Service Tools".
Restore electrical