MOTOR GP-GEAR 1912943 - Caterpillar

Removal Procedure
Start By:
Remove the fan drive. Refer to Disassembly and Assembly, "Fan Drive - Remove and Install". Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Drain the coolant to a level that is below the coolant tank. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change".
Illustration 1 g01276534
Disconnect hose (1).
Illustration 2 g01276535
Attach a suitable lifting device to fan (2). Remove fan (2). The weight of fan (2) is approximately 27 kg (60 lb). Installation Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Illustration 3 g01276535
Attach a suitable lifting device to fan (2). Position fan (2). The weight of fan (2) is approximately 27 kg (60 lb).
Illustration 4 g01276534
Connect hose (1).
Add coolant to the coolant system. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change". End By:
Install the fan drive. Refer to Disassembly and Assembly, "Fan Drive - Remove and Install".