MOTOR AS-BLOWER 1971932 - Caterpillar

that the Safety Information, Warnings, and Instructions are read and understood before operation or maintenance procedures are performed. In order to determine the maintenance interval, use the value that occurs first: fuel consumption , service hours , or calendar time .Before each consecutive interval is performed, all of the maintenance requirements from the previous interval must also be performed.The normal oil change interval is every 500 service hours or 12 months. Be sure to conduct controlled oil sampling at every 250 service hours or 6 months. The oil change interval may need to be reduced for some applications based on the controlled oil sampling results. Verify the proper oil change interval for the engine after satisfactory completion of the controlled oil sampling. When Required
Battery - Replace
Battery or Battery Cable - Disconnect
Engine - Clean
Engine Air Cleaner Element (Dual Element) - Clean/Replace
Fuel System - Prime
Severe Service Application - Check
Daily
Cooling System Coolant Level - Check
Driven Equipment - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Power Take-Off Clutch - Check/Adjust/Lubricate
Walk-Around Inspection
Every 250 Service Hours or 6 Months
Engine Oil Sample - Obtain
Every 250 Service Hours or 1 Year
Radiator - Clean
Every 500 Service Hours
Alternator and Fan Belts - Inspect/Adjust/Replace
Battery Electrolyte Level - Check
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Every 500 Service Hours or 6 Months
Engine Protective Devices - Check
Fuel System Primary Filter (Water Separator) Element - Replace
Fuel System Secondary Filter - Replace
Fuel Transfer Pump Strainer - Clean
Hoses and Clamps - Inspect/Replace
Every 500 Service Hours or 1 Year
Air Compressor Filter - Clean/Replace
Electronics Grounding Stud - Inspect/Clean/Tighten
Engine Oil and Filter - Change
Every 1000 Service Hours
Engine Valve Lash - Inspect/Adjust
Turbocharger - Inspect
Every 2000 Service Hours
Air Compressor - Inspect
Alternator - Inspect
Every 2000 Service Hours or 1 Year
Aftercooler Core - Inspect
Crankshaft Vibration Damper - Inspect
Engine Mounts - Inspect
Fuel Injection Nozzles - Test/Exchange
Every 2000 Service Hours or 2 Years
Cooling System Coolant Extender (ELC) - Add
Every 3000 Service Hours or 2 Years
Cooling System Coolant (DEAC) - Change
Cooling System Water Temperature Regulator - Replace
Starting Motor - Inspect
Water Pump - Inspect
Every 4000 Service Hours or 2 Years
Aftercooler Core - Clean/Test
Every 6000 Service Hours or 3 Years
Cooling System Coolant Extender (ELC) - Add
Every 6000 Service Hours or 6 Years
Cooling System Coolant (ELC) - Change
Every 8000 Service Hours or 1 Year
Engine Crankcase Breather - Clean/Replace
First 300 L (80 US gal) of Fuel or First 20 to 40 Service Hours
Engine Valve Lash - Inspect/Adjust
Every 13 000 L (3400 US gal) of Fuel or 250 Service Hours
Cylinder Head Grounding Stud - Inspect/Clean/Tighten
Overhaul
Overhaul Considerations