MOTOR GP-WINDOW WIPER 2031124 - Caterpillar

This application is equipped with an Operator Control Panel (OCP) 4.3 control panel. Additional information is available for this engine control and display. Refer to Systems Operation/Troubleshooting/Testing and Adjusting, UENR1210, "EMCP 4.3/4.4".
Illustration 1 g02419317
Components related to engine operation that are on the engine control panel (1) OCP display (2) Service tool connector (3) Emergency stop switchThe features of the control panel are described below.OCP Display
Illustration 2 g02419356
Locations of the control switches on the OCP display for engine operation (4) Display (5) Amber warning lamp (6) Red stop lamp (7) Event log switch (8) Engine control switch (9) Functional soft keys (10) Engine overview switch (11) Auxiliary equipment switch (12) Engine overview switchDisplay (4) - Information from the OCP is displayed on the display screen. This screen is used to display engine setup information, diagnostic information, and engine status.Amber warning lamp (5) - This lamp will illuminate when an engine fault is active.Red stop lamp (6) - This lamp will illuminate when an engine shutdown has occurred.Engine event switch (7) - This switch is used to display engine diagnostic events.Engine control switches (8) - These switches are used to control engine starting and stopping.Functional soft keys (9) - These keys are used to enable functions that are described in the soft key area of the display.Control switch (10) - This switch is used to enter the engine speed control menu.Auxiliary equipment switch (11) - Pressing the auxiliary equipment switch displays the first screen of auxiliary equipment information.Engine overview switch (12) - Pressing the engine overview switch displays the first screen of engine information. This initial information page contains various engine parameters that summarize the operation of the engine.Service Tool Connector
Use the service tool connector to connect an electronic service tool to the engine in order to communicate with the Electronic Control Module (ECM). Use the electronic service tool to service the engine.Emergency Stop Switch
Only stop the engine with the "EMERGENCY STOP" switch during an emergency situation. Do not use the "EMERGENCY STOP" switch for normal engine stopping.To prevent damage to the engine, use the mode "CONTROL" switch or the remote "START/STOP" switch for normal engine stopping.
Note: More than one emergency stop switch may be available for use on your application.The emergency stop switch is in the OUT position for normal engine operation. Press the switch for an emergency shutdown. When the emergency stop switch is pressed, the ECM immediately terminates ignition and the ECM immediately de-energizes the gas shutoff valve. The ECM logs a diagnostic code when the emergency stop switch is activated.The push switch includes a mechanical latch. The switch must be twisted clockwise in order to release. The emergency shutdown control must be released before the ECM can be reset.Note: This shutdown is latched. The ECM must be powered down prior to restarting the engine.In order to restart the engine, reset the emergency stop switch. Set the engine control to the "OFF" position. Then, use the engine control to start the engine. The engine will be restarted.