MOTOR GP-PISTON 2247399 - Caterpillar

2247399 MOTOR GP-PISTON Caterpillar parts PC206, PC310B

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA2247399
224-7399
2247399

Weight: 143 pounds 64 kg.

Buy MOTOR GP-PISTON 2247399 Caterpillar genuine, new aftermarket tractor parts with delivery
COLD PLANER,

Show more prices Caterpillar parts

Compatible equipment models: 2247399:

COLD PLANER PC206 PC310B Caterpillar

Number on catalog scheme: 1

Caterpillar 2247399 Parts scheme MOTOR GP-PISTON

For full view, you need register

Information:

Test Procedure
System Operation
The SLC 5/04 - 5/05 indicators are located on the front of the following components: Power Supply, CPU and I/O Modules.The diagnostic indicators help trace the source of the fault. Faults can be found in the following components: input devices, output devices, wiring and the controller.The green "RUN" LED is illuminated. The processor is in the "RUN" mode.The red "FLT" LED is flashing during operation. The processor detects a major fault. The fault is in the processor expansion chassis or the fault is in the memory.The amber "FORCE" LED is illuminated. The forces are enabled.The amber "FORCE" LED is not illuminated. No forces are present or no forces are enabled.
Illustration 1 g00563544
Diagram of the LED indicators
Illustration 2 g00562937
Central Processing Unit for typical systemFunctional Test
Check the electrical connectors and check the wiring.
Bodily contact with electrical potential can cause bodily injury or death.To avoid the possibility of injury or death, ensure that the main power supply has been disconnected before performing any maintenance or removing any modules.
Disconnect the power supply.
Check the electrical connectors and check the wiring for damage or bad connections.
Verify that all modules are properly seated.
Verify the status of the LED on the SLC 5/04 - 5/05.The results of the preceding procedure are in the following list:
All of the components are fully installed. All of the components are free of corrosion. All of the components are free of damage. All of the modules are properly seated. Proceed to 2.
The components are not fully installed. The components are not free of corrosion. The components are damaged. All of the modules are not properly seated. Repair the component. Verify that the repair resolves the problem. STOP.
Clear the fault.
Place the switch in the PROG position.
Place the switch in the RUN position.The results of the preceding procedure are in the following list:
No errors are displayed on the LED indicators. Stop.
Errors are displayed on the LED indicators. Proceed to 3.
Cycle the power.
Secure power to the PLC.
Energize the PLC.The results of the preceding procedure are in the following list:
No errors are displayed on the LED indicators. Stop.
Errors are displayed on the LED indicators. Refer to Maintenance Procedure, "Processor - Replace".