AVSPARE.COM
parts catalog

MOTOR GP-PISTON 2288527 - Caterpillar


2288527 MOTOR GP-PISTON Caterpillar parts 938G II, 950G II, 950H, 962G II
Rating:
22
Alternative (cross code) number:
CA2288527
228-8527
2288527
Caterpillar 2288527 MOTOR GP-PISTON
Weight: 32 pounds 14 kg.

Buy MOTOR GP-PISTON 2288527 Caterpillar genuine, new aftermarket tractor parts with delivery
WHEEL LOADER,

Related part:
2288527  MOTOR GP-HYD  10R3339  R

You can buy:

 
$750

27 Jan 2017
MOVO Hydraulics

Compatible equipment models: 2288527:

WHEEL LOADER  938G II   950G II   950H   962G II   Caterpillar
Number on catalog scheme: 26
  For full view, you need register

Information:


Illustration 1 g01004631
Schematic of the transmission solenoid 6This diagnostic code is associated with the transmission solenoid 6. The FMI 06 means that the ECM has determined that the current of the solenoid is above normal. The possible causes of this diagnostic code are listed:
The energize circuit of the solenoid is shorted to ground.
The solenoid has failed.
The ECM has failed. This is unlikely.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 0636 FMI 06 is active before performing this procedure.Note: Use the 146-4080 Digital Multimeter for the measurements in this procedure.System Response:When this diagnostic code is active, the ECM will turn off the current to the failed solenoid.Test Step 1. CHECK THE SOLENOID
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine.
Observe the status of the diagnostic code.
Disconnect the solenoid with the active diagnostic code from the machine harness. Expected Result:CID 0636 FMI 06 changes to CID 0636 FMI 05 when the solenoid is disconnected.Results:
YES - CID 0636 FMI 06 changes to CID 0636 FMI 05 when the solenoid is disconnected. The circuit is correct.Repair: The solenoid has failed. Repeat this test "CHECK THE SOLENOID" in order to verify the solenoid failure. Replace the solenoid. Stop.
NO - CID 0636 FMI 06 remains active. Proceed to Test Step 2.Test Step 2. CHECK THE SOLENOID ENERGIZER CIRCUIT FOR A SHORT TO GROUND
Turn the key start switch and the disconnect switch to the OFF position.
The solenoid remains disconnected from the machine harness.
Disconnect the machine harness connector(s) from the ECM.
At the machine harness connector, measure the resistance from the signal contact J2-2 (wire 901-WH) to all contacts that are used in the machine harness connectors for the ECM.Expected Result:Each resistance measurement is greater than 5 ohms.Results:
OK - Each resistance measurement is greater than 5 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - Each resistance measurement is not greater than 5 ohms. There is a short in the machine harness. The short is between J2-2 (wire 901-WH) and the circuit with the low resistance measurement.Repair: Repair the machine harness or replace the machine harness. Stop.Test Step 3. CHECK IF THE DIAGNOSTIC CODE REMAINS
Inspect the harness connectors and clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Operate the machine.
Check the status of the CID 0636 FMI 06.Expected Result:The CID 0636 FMI 06 is active.Results:
YES - The CID 0636 FMI 06 is active. The diagnostic code has not been corrected. The ECM may have failed.Repair: It is unlikely that the ECM has failed. Exit this procedure and perform this procedure again. If the cause of the diagnostic code is not found, replace the ECM. Refer to Systems Operation, Troubleshooting, Testing and Adjusting, "Electronic Control Module (Power Train) - Replace" for the machine that is being

Caterpillar parts catalog:

Caterpillar parts catalog
Fan Control Ar (Auto Reversing) Custom Product Support Literature for the 938G Series II Wheel Loaders CRD00001-UP (MACHINE)
2Q-8245 Control Ar-Fan (Auto Reversing) (Kit) Custom Product Support Literature for the 950G Series II and the 962G Series II Wheel Loaders AXR00001-UP (MACHINE)
962G II Wheel Loader BAD00001-UP (MACHINE) POWERED BY 3126B Engine
950G II WHEEL LOADER BAA00001-UP (MACHINE) POWERED BY 3126B Engine
950G II Wheel Loader AXR00001-UP (MACHINE) POWERED BY 3126B Engine
950G II Wheel Loader AXX00001-UP (MACHINE) POWERED BY 3126B Engine
962G II Wheel Loader AXY00001-UP (MACHINE) POWERED BY 3126B Engine
962G II Wheel Loader AXS00001-UP (MACHINE) POWERED BY 3126B Engine
938G II Wheel Loader RTB00001-UP (MACHINE) POWERED BY 3126B Engine


Parts motor Caterpillar catalog:

1555783 MOTOR GP-WINDOW WIPER
910G, 914G, 924G, 924GZ, 924H, 924HZ, 928G, 928H, 928HZ, 930G, 938G, 938G II, 938H, CP-433E, CP-44, CP-533E, CP-56, CP-573E, CP-64, CP-663E, CP-76, CS-423E, CS-433E, CS-44, CS-531D, CS-533D, CS-533E, ...
1555784 MOTOR GP-WINDOW WIPER
814F, 814F II, 815F, 815F II, 816F, 816F II, 844, 844H, 854G, 854K, 910G, 914G, 924G, 924GZ, 924H, 924HZ, 928G, 928H, 928HZ, 930G, 938G, 938G II, 938H, 990 II, 990H, 992G, 992K, 994F, CP-433E, CP-573E...
1555789 MOTOR GP-WINDOW WIPER
824G, 824G II, 824H, 825G, 825G II, 825H, 826G, 826G II, 826H, 834G, 834H, 836G, 836H, 950G, 950G II, 950H, 962G, 962G II, 962H, 966G, 966G II, 966H, 972G, 972G II, 972H, 980G, 980G II, 980H, 988G, 98...
1477969 MOTOR GP-WINDOW WIPER
914G, 924GZ, 928G, 938G, 938G II, IT14G, IT28G, IT38G
1898622 MOTOR GP-WINDOW WIPER
824K, 825K, 826K, 834K, 836K, 950G II, 950H, 962G II, 962H, 966G II, 966H, 972G II, 972H, 980G II, 980H, 986H, 988K, IT62G II, IT62H
1912943 MOTOR GP-GEAR
938G II, 950G II, 962G II, IT38G II, IT62G II
1741486 MOTOR AS-BLOWER
30/30, 307, 307B, 312, 312B L, 315, 315B L, 317, 317B LN, 318B, 320B, 322B L, 322B LN, 325B L, 325D FM LL, 330, 330B L, 330D FM, 345B, 345B II, 345B II MH, 345B L, 350, 365B, 365B II, 375, 375 L, 385B...
1350611 MOTOR GP-WINDOW WIPER
120H, 120K, 120K 2, 120M, 120M 2, 12H, 12K, 12M, 12M 2, 12M 3, 12M 3 AWD, 135H, 140H, 140K, 140K 2, 140M, 140M 2, 140M 3, 140M 3 AWD, 143H, 14H, 14M, 160H, 160K, 160M, 160M 2, 160M 3, 160M 3 AWD, 163H...
1836967 MOTOR GP-ELECTRIC
583T, 587R, 587T, 938G, 938G II, 938H, 950 GC, 950G, 950G II, 950H, 962G, 962G II, 962H, 966G, 966G II, 966H, 972G, 972G II, 972H, 993K, D10T, D11R, D11T, D8T, D9T, IT38G, IT38G II, IT38H, IT62G II, I...
2756706 MOTOR AS-BLOWER
583T, 587R, 587T, 613G, 621G, 623G, 627G, 631G, 637G, 657G, 725, 725C, 730, 730C, 735, 735B, 740, 740B, 770, 770G, 770G OEM, 772, 772G, 772G OEM, 914G, 924G, 924GZ, 924H, 924HZ, 924K, 928G, 928H, 930G...
2056029 MOTOR AS-ELECTRIC
550, 550B, 560B, 570, 570B, 580, 580B, 824G, 825G, 938G, 938G II, 938H, 950G, 950G II, 950H, 962G, 962G II, 962H, 966G, 966G II, 966H, 972G, 972G II, 972H, 980G, 980G II, IT38G, IT38G II, IT38H, IT62G...
2688792 MOTOR AS-BLOWER
950G II, 950H, 962G II, 962H, 966G II, 966H, 972G II, 972H, 980G II, 980H, 986H, D10T, D10T2, D11T, D8T, D9T, IT62G II, IT62H
1507267 MOTOR & FAN GP
938G, 950G, 962G, IT38G
3349979 MOTOR GP-SWING
330C, 330C FM, 330C L, 330C MH, 330D, 330D FM, 330D L, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E H, 336E HVG, 336E L, 336E LH, 336E LN, 336F L, 340D L, 340D2 L, 568 FM LL
1799775 MOTOR GP-SWING
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 2491, 2590, 325C, 325C FM, 325D, 325D L, 328D LCR, 329D, 329D L, 329D LN, 511, 521, 522, 532, 541, 551, 552, M325C MH, M325D L MH, M325D MH, TK711, TK...
6G4350 MOTOR GP-WIPER
768B, 769, 772, 773
4234217 MOTOR GP-WINDOW WIPER
950K, 962K, 966K, 966M, 966M XE, 972K, 972M, 972M XE, 980K, 980M, 982M
3305053 MOTOR GP-WINDOW WIPER
826H, 836H, 950H, 962H, 966H, 972H, 980H, 988H
1799778 MOTOR GP-PISTON
322C, 322C FM, 325C, 325C FM, M325C MH
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.