MOTOR GP-PISTON 2541352 - Caterpillar

Illustration 1 g00732198
Turn the engine speed dial to the operating range.
Move the hydraulic lockout control to the UNLOCKED position.
Illustration 2 g02145475
Raise the boom enough to provide sufficient ground clearance.
Illustration 3 g03262356
Select the desired travel speed by operating the travel speed control switch.
Make sure that the position of the upper structure and of the undercarriage is known before you move the machine. The drive sprockets should be at the rear of the machine.Note: The directional steering controls will operate normally if the drive sprockets are at the rear of the machine and the idlers are at the front of the machine and under the cab. When the sprockets are under the cab, the travel controls will operate backward.
Turn the engine speed dial to increase the engine speed (rpm) to the desired speed.
Push both travel levers forward at the same time to travel forward. If both travel levers are pushed farther, the travel speed at the selected engine speed (rpm) will be faster.Note: If the machine does not operate or if the machine does not travel in a straight line, consult your Caterpillar dealer.
See Operation and Maintenance Manual, "Operator Controls" for information about spot turning and about pivot turns.
When you make turns in soft material, travel in a forward direction occasionally to clear the tracks.
Slowly move both of the travel levers or both of the travel pedals to the CENTER position to stop the machine.Lifting Objects
If the machine is equipped with the CE plate per requirements for the European Union, used to lift objects, then the machine must be equipped with the optional boom lowering control valve and an overload warning device.A fit for purpose test was completed to confirm that a properly equipped machine meets the requirements of the European Union Machinery Directive "2006/42/EC" for lifting objects.The overload warning device (if equipped) must be adjusted for the bucket linkage and bucket size that is installed on the machine. Adjust the overload warning device for proper operation.The setting for the overload warning device (if equipped) should be checked by an authorized dealer.