MOTOR GP-PISTON 2694749 - Caterpillar

Menu Selections
Language
Illustration 1 g01048315
The Language menu allows you to choose a language from the languages that are supported by the software.
"English"
"Spanish"
"German"
"French"
"Italian"
"Dutch"
"Portuguese"
"Finnish"
"Swedish"
"Norwegian"Valve Calibration
The Valve Calibration menu allows you to set the lift and tilt valve's upper and lower limits by manually adjusting the blade.This calibration wizard will guide the user through the required actions for performing an automatic valve calibration. The following menus are used.
"Set Lower Limit"
"Set Upper Limit"
"Confirm Start"
"Calibration Status"
"Exit-Success"
"Exit-Error"The Exit-Success screen will be displayed after a successful automatic calibration of the valve has been completed. The Exit-Error screen will show a description of the error that occurred during the automatic calibration of the valve.Format of the Screen
Illustration 2 g01052073
(5) "Laser Strike Indicator" (6) "Laser Strike Window" (7) "Laser Strike Limit Range" (8) "Laser Strike Value" (9) "Success Indicator" (10) "Number of screens"The top banner of the of the display will show the text that is listed below:"<- Auto Valve Cal" - This message is displayed when the lift valve is calibrated. (dual mast system and single mast system)"Auto Valve Cal ->" - This message is displayed when the tilt valve is calibrated. (dual mast system only)The information displayed is for the sensor that is used during calibration. After selection, both the upper calibration and the lower calibration limits are displayed.The OK / right reset button is used to continue the process of calibration.The ESC / left reset button is used to abort the calibration process.The activity indicator is activated in order to convey to the user that a sensor signal is available and that the calibration is in progress even if you do not observe any blade motion.Press the ESC / left reset button from any screen of the Automatic Valve Calibration Wizard in order to terminate the calibration in progress. If the user is in the Calibration Status screen, this action shows the Exit-Error Screen, with the text Abort. In all other screens, the user is returned to the Auto Valve Cal screen.Linked Elevation Calibration (Dual Mast System Only)
The Linked Elevation Calibration menu allows for the height difference (offset) between the mounts for the electric masts .Linked Elevation Calibration is necessary in order to measure the difference between the right mast mount and the left mast mount. Linked elevation calibration is also necessary in order to record the difference of the elevation between the right mast mount and the left mast mount. The AccuGrade Laser System uses this measurement in order to compensate for the height difference between the mast mounts.The Linked Elevation Calibration menu is available only when the Linked Elevation operating mode is active.Note: A laser transmitter and a carpenter's level are required in order to complete the Linked Elevation Calibration.Remote Switches
The Remote Switches menu is not operational. This menu is reserved for future use.Reset to Defaults
The Reset to Defaults menu allows the user to reset all of the factory settings to the default value except for valve calibration, manual tune, and linked elevation calibration.Menu Foldouts
Installation Menu (Dual Mast System)
Illustration 3 g01098660
Installation Menu (Single Mast System)
Illustration 4 g01053229