MOTOR GP-PISTON 2806824 - Caterpillar

Illustration 1 g03326196
Schematic of the CAN A Data Link circuit
The CID 0247 diagnostic code is associated with the CAN A Data Link circuit. The FMI 09 diagnostic code is recorded when the Implement ECM stops receiving information on the CAN Data Link.Note: The resistance of the CAN A Data Link circuit should measure approximately 60 ohms between circuit components. The possible conditions that can cause the Implement ECM to activate this diagnostic code are listed:
An open or a poor connection in the CAN A Data Link circuits near the Implement ECM.
The data link terminating resistor circuits are open or are disconnected. This condition would result in multiple active CAN A codes from multiple control modules.
A short circuit to ground or to another circuit. This condition would result in multiple active CAN A codes from multiple control modules.
An Implement ECM software problem.
The Implement ECM has failed. This condition is unlikely.Test Step 1. INSPECT THE HARNESS CONNECTIONS
Turn the key start switch and the disconnect switch to the OFF position.
Inspect all harness connections that are related to the CAN A Data Link. Make sure that the connectors are clean and that the connectors are tight.
Check the connectors for proper mating. Ensure that all the seals are present and in place.
Check the harness for signs of damage or abrasion.
Check the wires at the connector. Ensure that the wires are secured tightly into the connector. Note: Take care not to pull the wire out of the connector.
Check the exposed wires at the connectors for nicks or signs of abrasion.
Check for moisture inside the connector.
Check the connectors for dirty contacts or corroded contacts.
Check each pin and each socket of the machine harness connectors. Ensure that the contacts are properly installed. The contacts should mate correctly when the two pieces of the connector are placed together. Expected Result:The machine harness connectors are tight and free of corrosion.Results:
OK - The machine harness connectors are tight and free of corrosion. Proceed to Test Step 2.
NOT OK - The machine harness connectors are in need of repair.Repair: Repair the machine harness or replace the machine harness.STOPTest Step 2. CHECK FOR SHORTS TO GROUND
The disconnect switch remains in the OFF position.
Disconnect the machine harness connectors from all electronic control modules that use the CAN A Data Link.
At the machine harness for the Implement ECM, measure the resistance between frame ground and connector contacts J2-67 (wire F711-GN(Green)) and J2-68 (wire F712-GY(Grey)) of the CAN A Data Link circuit. Expected Result:The resistance is greater than 5000 ohms.Results:
OK - The resistance is greater than 5000 ohms. The harness circuit resistance is correct. Proceed to Test Step 3.
NOT OK - The resistance is less than 5000 ohms. The machine harness has failed. There is a short between frame ground and contacts J2-67 (wire F711-GN(Green)) and J2-68 (wire F712-GY(Grey)) of the data link circuit in the machine harness.Repair: Repair the machine harness or replace the machine harness.STOPTest Step 3. CHECK FOR SHORT TO THE +BATTERY CIRCUIT
The disconnect switch remains in the OFF position.
All