MOTOR GP-SWING 2959436 - Caterpillar

When you are using hydraulic cylinders and puller studs, always ensure that the rated capacity of the puller stud meets or exceeds the rated capacity of the hydraulic cylinder. If the puller stud does not meet or exceed the rated capacity of the hydraulic cylinder, a sudden failure of the puller stud could occur. The sudden failure of the puller stud could result in personal injury or death.
Make sure that the bores in the power link and the bore in the stick are thoroughly clean and free of dirt and debris prior to the installation of the sleeve bearings. Note: Make sure that the bearings are installed in the bore so that the identification numbers of the bearings are facing outward.
Illustration 1 g00698602
Lower the temperature of sleeve bearings (5) that will be installed in the closed end of power link (2).
Use Tooling (D) to install sleeve bearings (5) in the closed end of power link (2). Install the sleeve bearings until Dimension (X) is achieved. Dimension (X) should equal 9.50 0.80 mm (0.374 0.032 inch).
Illustration 2 g01433191
Use Tooling (E) to install lip seal (4) in the closed end of power link (2). Install lip seals (4) with the sealing lip toward the outside of the bore. Install the lip seals below the outside surface of the power link.
Illustration 3 g00698673
Lower the temperature of sleeve bearings (3) that will be installed in the open end of power link (2).
Use Tooling (F) to install two sleeve bearings (3) in the open end of power link (2). Install the sleeve bearings until Dimension (Y) is achieved. Dimension (Y) should equal 9.73 0.20 mm (0.383 0.008 inch).
Illustration 4 g01433124
Use Tooling (E) to install lip seals (1) in power link (2). Install lip seals (1) with the sealing lip toward the outside of the bore. Install the lip seals below the outside surface of the power link.
Illustration 5 g00698695
Illustration 6 g01433874
View A-A
Lower the temperature of two sleeve bearings (7) that will be installed in the stick.
Use Tooling (G) to install sleeve bearings (7) in the stick. Install the sleeve bearings until Dimension (Z) is achieved. Dimension (Z) must be 9.50 0.80 mm (0.374 0.032 inch).
Illustration 7 g01433127
Use Tooling (E) in order to install lip seals (6) in the stick. Install the lip seals with the sealing lip toward the outside of the bore. Install the lip seals below the outside surface of the stick.
Apply a thin coat of Tooling (C) to all sleeve bearings.
Apply a thin coat of Tooling (C) to the sealing lip of all lip seals. End By:
Install the bucket control linkage. Refer to Disassembly and Assembly, "Bucket Linkage - Install".