MOTOR AS-BLOWER 2962602 - Caterpillar

Remove thrust washers (22) and planetary gear (24) from the carrier assembly.
Remove bearing (23) from planetary gear (24) .
Repeat Steps 16.a through 16.e for the other two planetary.
Illustration 15 g00781529
Remove gear (25) . Remove spacer (26) .
Illustration 16 g00781559
Remove carrier assembly (27) .
Use two people to remove carrier assembly (27) . The weight of the carrier assembly is approximately 38 kg (85 lb).
Disassemble carrier assembly (27) , as follows.
Illustration 17 g00781719
Drive spring pin (29) into planetary shaft (28) with a hammer and a punch.
Illustration 18 g00781601
Remove planetary shaft (28) .
Remove spring pin (29) from planetary shaft (28) with a hammer and a punch.
Illustration 19 g00781607
Remove thrust washers (30) and planetary gear (32) from the carrier assembly.
Remove two bearings (31) from the planetary gear.
Repeat Steps 21.a through 21.e for the other two planetary gears.
Illustration 20 g00781730
Use two people to remove gear (33) . The weight of gear is approximately 41 kg (90 lb).
Illustration 21 g00781807
Remove O-ring seal (34) .
Illustration 22 g01147650
Remove bolts (35A) and plates (35B) .
Illustration 23 g01147651
Use Tooling (G) to remove dowel (37) from stopper plate (35) .
Illustration 24 g01147759
Secure Tooling (D) to stopper plate (35) . Use Tooling (D) to remove stopper plate (35) .
Illustration 25 g01147930
Use Tooling (E) and a suitable lifting device to remove housing (36) . The weight of housing (36) is approximately 100 kg (220 lb).
Illustration 26 g01147951
Remove Duo-Cone seal (39A) from housing (38) .
Illustration 27 g01147975
Illustration 28 g01147934
Remove Duo-Cone seal (39B) from housing (36) .
Use Tooling (F) in order to remove bearings (40) and (41) from housing (36) .
If necessary, remove the final drive sprocket from the sprocket housing. Refer to Disassembly and Assembly, "Final Drive Sprocket - Remove and Install".