MOTOR GP-SWING 3349980 - Caterpillar

TYPE="LEVEL" DEPTH="1" @@@--> For all generator maintenance activities, refer to the Operation and Maintenance Manual for your generator.Use fuel consumption, service hours, or calendar time, whichever occurs first, to determine maintenance intervals. Experience has shown that maintenance intervals are most accurately scheduled on the basis of fuel consumed rather than service hours. Daily Walk-Around Inspection - Inspect engine for leaks and loose connections Engine Crankcase - Check oil level Cooling System - Check coolant level Air Cleaner - Check service indicator/Service air cleaner when needed First 9500 L (2500 gal) of Fuel or 250 Hours (First Oil Change) Valve Lash - Check/Adjust Magnetic Pickup - Inspect/Adjust Every 9500 L (2500 gal) of Fuel or 250 Hours S O S Oil Analysis - Obtain Sample and analysis Engine Crankcase - Replace oil and oil filter Crankcase Breather - Clean Cooling System (Conventional HD Coolant/Antifreeze Only) - Test for SCA concentration OR obtain Level I coolant analysis/Add SCA if necessary Fuel System - Clean primary fuel filter/Replace final fuel filter Radiator, Aftercooler - Clean/Inspect Belts - Check/Adjust Hoses and Clamps - Inspect/Replace Fan Drive Bearing - Lubricate Batteries - Clean/Check (if required) Every 28,500 L (10,000 gal) of Fuel or 1000 Hours Engine Protective Devices - Inspect/Check Fuel Control Linkage - Check/Lubricate Every 2000 Hours or One Year Engine Mounts - Inspect Every 114,000 L (30,000 gal) of Fuel or 3000 Hours or Two Years Water Temperature Regulator (Thermostat) - Replace1 Cooling System (Conventional HD Coolant/Antifreeze Only) - Drain/Clean/Replace Coolant Valve Lash, Valve Rotators - Check/Adjust Fuel Ratio Control, Set Point, and Low Idle - Check/Adjust Crankshaft Vibration Damper - Inspect Every 3000 Hours or Three Years Cooling System (Extended Life Coolant Only)- Add Extender Every 190,000 L (50,000 gal) of Fuel or 5000 Hours Fuel Injection Nozzles - Test/Exchange Turbocharger - Clean/Inspect/Check Water Pump - Inspect/Replace seal Alternator - Inspect/Rebuild or Exchange Starting Motor - Inspect/Rebuild or Exchange Magnetic Pickup - Inspect/Adjust Every 228,000 L (60,000 gal) of Fuel or 6000 Hours or Four Years Cooling System (Extended Life Coolant Only) - Drain/Flush/Replace Coolant OverhaulContact your Caterpillar dealer for overhaul information and specific overhaul programs for your engine.1If a commercial HD coolant meeting ASTM D4985 specifications is used, or if a mixture of commercial SCA and water is used, this maintenance should be performed at a maximum of One Year.