MOTOR GP-PISTON 3374018 - Caterpillar

Illustration 1 g01216881
(1) System Status (2) Over Pressure Indicator (3) "Over Temperature Indicator" (4) System Problem Indicator (35) Alarm Reset IndicatorThe four operational lights on the diagnostic module must be monitored daily.Note: Any alarm events must be investigated immediately. Failure to resolve the problem may result in severe damage to the monitor or the engine.
The "System Status" light is green when the light is illuminated. The "System Status" light will blink once for every 2 seconds during normal operation. The blinking "System Status" light indicates that power is being supplied to the module. If the "System Status" light is not blinking, the diagnostic module has no power.
If the exhaust back pressure has exceeded 24 kPa (95 inches of H2O) for 5% of a one hour interval, then a yellow light on the dash panel will illuminate. Note this reading in the maintenance log and continue normal operation without excess idling. No light on the diagnostic module will illuminate.
If the exhaust back pressure has exceeded 27 kPa (109 inches of H2O) for 5% of a one hour interval, then the "Over Pressure" lamp (2) will illuminate. A red warning light in the cab will also illuminate. The illumination of these lights indicates that the DPF needs to be cleaned as soon as possible. The engine will stop if the back pressure exceeds 27 kPa (109 inches of H2O).
If the "Over-Temperature" light is illuminated, the exhaust temperature is too high.
If the "System Problem" light is illuminated, then one or more sensors have failed.
After the DPF has been cleaned, the "Alarm Reset" button (5) on the diagnostic module must be pressed in order to reset the warning lights on the module.
Table 1
Troubleshooting Guide for the Diagnostic Monitor    
Illuminated Light     Explanation    
The green "System Status" is not flashing.     The diagnostic module has no power. If no noticeable loss of engine power has occurred, the vehicle may be safely driven to a Caterpillar dealer.    
"System Status" light is blinking and the red "System Problem" light is illuminated.     One or more of the sensors has malfunctioned. Alert maintenance. The vehicle can be safely driven to a Caterpillar dealer.    
"System Status" light is blinking. The red "Over Temperature" light is illuminated and the red "System Problem" light is illuminated.     The exhaust temperature probe has failed. Alert maintenance. The vehicle can be safely driven back to a Caterpillar dealer.    
"System Status" light is flashing and the "Over Temperature" light is illuminated.     The exhaust temperature is too high. Alert maintenance. The vehicle can be safely driven to a Caterpillar dealer.    
"System Status" light is blinking and the red "Over Pressure" light is illuminated.     The exhaust back pressure has exceeded operational limits. If the "Over Pressure" light on the diagnostic module is illuminated, the filter must be cleaned as soon as possible. When the red "Over Pressure" dash light illuminates, the filter must be cleaned as soon as possible. Failure to clean the filter will probably result