MOTOR AS-WINDOW WIPER 3467441 - Caterpillar

1. Start the engine. Maintain the oil between the ADD and FULL marks on dipstick (1).2. Add oil if necessary through fill tube (2).3. Clean and install the fill plug. Stop the engine.Hydraulic Tank Oil
Check Oil Level
The hydraulic oil tank is located on the right side of the machine. 1. Maintain the oil level to the FULL mark in the sight gauge.2. Remove the oil fill cap and add oil, if necessary, through the fill tube.3. Clean and install the fill cap.Radiator
Check Coolant Level
The radiator cap is located in the hood on the right front of the machine.1. Remove the radiator cap slowly to relieve pressure.2. Maintain the coolant level to within 13 mm (.50 in) of the bottom of the fill pipe. If it is necessary to add coolant daily, check for leaks.3. Inspect the cap and cap seal for damage, deposits or foreign material. Clean the cap with a clean cloth or replace the cap if it is damaged.4. Install the cap.5. Inspect the radiator core for debris and clean if necessary.Compressed air is preferred, but high pressure water or steam can be used to remove dust, leaves and general debris from a radiator. Clean as required by condition of radiator.Fuel Tank Drain Valve
Drain Water and Sediment
Drain valve is located on the left rear of the machine. Open the cover. 1. Open the drain valve and allow the water and sediment to drain.2. Close the drain valve.3. Close the cover.Walk-Around Inspection
Inspect Machine
Inspect the final drive for leaks. Correct any leaks.Inspect the hydraulic system for leaks. Inspect the tank, hoses, tubes, plugs, joints and fittings. Correct any leaks.Inspect the steps, walkways and handholds for their condition and cleanliness.Inspect the lights for broken bulbs and lenses. Replace if broken.Inspect the transmission for leaks.Inspect the tracks for damage and excessive wear. Repair any damaged track. Tighten any loose bolts and replace any that are missing.Be sure the covers and guards are firmly in place. Inspect for damage. Inspect the engine precleaner screen. Remove any dirt and debris build-up.Inspect the cooling system for leaks, faulty hoses and trash build-up. Correct any leaks and remove any trash from radiator.Inspect and remove any trash build-up in the engine compartment. Check for oil and fuel leaks. Correct any leaks. Inspect the operator's compartment for cleanliness. Keep it clean.Inspect the instrument panel for broken gauges and indicator lights. Replace if broken.Make sure the horn and backup alarm are in proper working order.Seat Belt
Inspect for Wear or Damage
Replace the seat belt after three years of usage, regardless of appearance. Seat belt and mounting hardware must be inspected for wear or damage before operating the machine. Replace the belt or mounting hardware if worn or damaged.Brakes, Indicators and Gauges
Test for Proper Function
Look for broken gauge lenses or indicator lights, switches, etc.Start the engine.Look for inoperative gauges.Turn all machine lights on. Check for proper operation.Sound the forward horn.Move the machine forward and test the service brakes. If service brakes do not function properly refer to the topic