MOTOR & MTG GP-HYDRAULIC FAN 3596451 - Caterpillar

44. Install seal (90) on plug (89). Put SAE 30 oil on the seal and push the plug into No. 3 clutch housing (88). Install the retainer ring that holds the plug in the housing.45. Install two seal rings (92) on No. 3 clutch piston (91). Put SAE 30 oil on the seals.46. Install No. 3 piston (91) in No. 3 clutch housing (88).47. Install five pins (94) in the manifold. Install three discs (93) and two plates (95). Start and stop with a disc. Install fifteen springs (96) as shown.48. Use tooling (F) to hold the piston in the No. 3 clutch housing. Install the housing assembly on the manifold. Be sure the springs are in position between the housing and the clutch plates. Install the bolts and washers that fasten the housing to the manifold. 49. Install O-ring seal (98) on the No. 7 clutch housing. Put SAE 30 oil on the seal. Install tooling (B) on case (97) and fasten a hoist as shown. Install the case on the No. 7 clutch housing. Install the four bolts and lockwashers that fasten the case to the housing. The weight of the case is 480 lb (216 kg).50. Install seal ring (101) on housing (99). Install bearing (100) in the housing. Be sure the notch in the inner race of the bearing is down.51. Install housing (99) on hub (103). Install bolts (104) and washers that fasten the housing to the hub. Install seal ring (102) on the housing.52. Install seal ring (106) on No. 1 piston (105) and put SAE 30 oil on the seal. Install the piston in the hub. 53. If carrier (108) was removed from manifold (107), heat the new carrier to a temperature of 275°F (135°C) and install it on the manifold. One of the grooves in the carrier must be in alignment with the pin hole in the manifold. Install pin (110) that holds the carrier on the manifold.54. Install two seal rings (109) on the carrier.55. Install two 1/2" -13 NC forged eyebolts in the hub and fasten a hoist as shown. Install the hub on the manifold. Be sure the notch in bearing (100) is in alignment with dowel (111) in the manifold.56. Install retainer ring (112) that holds the manifold in the hub assembly.57. Install seal ring (116) on piston (113) and put SAE 30 oil on the seal. Install twelve springs (115) in piston (105). Install two 3/8" -16 NC guide bolts (114) in the hub assembly as shown and put piston (113) in position in the hub assembly. Install the six bolts and washers that fasten the piston to the hub assembly. 58. Install retainer ring (117) in hub (118).59. Put shaft (119) in position in hub assembly (103). Install hub (118) on the shaft.60. Install five plates (120) and four discs (121) between hubs (103) and (118). Start and stop with a plate.61. Put SAE 30 oil on bearings (124) and