MOTOR AS 4202395 - Caterpillar

Engine Rating Parameter
"Rating Number"
The "Rating Number" corresponds to the selected set of performance maps for the application. Factory passwords are required in order to change the "Rating Number".ECM Identification Parameter
Equipment ID
"Equipment ID" is the identification of the equipment that is assigned by the customer. This parameter allows the customer to enter a description into the ECM in order to identify the engine's application. A maximum of 17 characters can be entered in the field.Miscellaneous
Monitoring Mode Shutdowns
"Monitoring Mode Shutdowns" controls the shutdown feature that is associated with the engine monitoring feature.J1939 Continuous Fault Handling
Remote Torque Speed Control Enable Status
The "Remote Torque Speed Control Enable Status" parameter determines the way that faults will be handled by the ECM when the "J1939 Torque Speed Control (TSC1)" message is used as a speed request input to the ECM.Configurable Inputs
Overspeed Protection
The "Overspeed Protection" speed is the engine rpm when a shutdown will occur. Overspeed protection is used in order to protect the engine from damage. Overspeed protection must be enabled in "Monitoring Mode Shudowns".Configurable Governor Droop
"Configurable Governor Droop" allows the engine to run in "droop mode" when the genset is operated in parallel with other gensets.Coolant Level Sensor
Programming the "Coolant Level Sensor" parameter to "Enabled" notifies the ECM that a coolant level sensor input is present on pin J1:38. If this parameter is programmed to "Enabled" and the coolant level falls below the measured level, a "E2143-3" event code will be displayed.Air Filter Restriction Switch Installation Status
An "Air Filter Restriction Switch" is an optional switch input. Programming the "Air Filter Restriction Switch Installation Status" parameter to "Enabled" notifies the ECM that an input from the air filter restriction switch is present on pin J1:47. When this parameter is programmed to "Enabled" and the air filter restriction switch closes, an E172-1 or J107-15 event code will be displayed.Fuel/Water Separator Switch Installation Status
A fuel/water separator switch is an optional switch input. Programming the "Fuel/Water Separator Switch Installation Status" parameter to "Enabled" notifies the ECM that a fuel/water separator switch input is present on pin J1:44. When this parameter is programmed to "Enabled" and the fuel/water separator switch closes, an E232-1 or J97-15 event code will be displayed.User Defined Switch Installation Status
A user defined shutdown switch is an optional switch input. Programming the "User Defined Switch Installation Status" parameter to "Enabled" notifies the ECM that a user defined switch input is present on pin J1:48. If this parameter is programmed to "Enabled" and the user defined shutdown switch closes, the engine will shut down.