MOTOR GP-PISTON 4816776 - Caterpillar

Illustration 1 g06180324
(1) Stick Out
(2) Swing Right
(3) Stick In
(4) Swing Left
(5) Boom Lower
(6) Bucket Dump
(7) Boom Raise
(8) Bucket Close
(9) HOLD
The Fine Swing Control delays the engagement of the swing parking brake.If the machine is operating on a slope with the Fine Swing Control in the ON position, the swing motion may become uncontrollable which could result in property damage, personal injury or death.Turn the Fine Swing Control to the OFF position when the machine is operating on a slope.
When you release the joysticks from any position, the joysticks will return to HOLD position (9). Movement of the upper structure will stop unless the fine swing control (if equipped) is ON. When the fine swing control is ON, the swing parking brake will not activate until 6.5 seconds after the joystick control for the swing function returns to the HOLD position.Two functions may be performed at the same time by moving a joystick diagonally.The machine control pattern is initially set at the factory to the SAE system, as shown. The pattern on the left pertains to the left joystick and the pattern on the right pertains to the right joystick.The machine control pattern can be varied. Refer to Operation and Maintenance Manual, "Joystick Controls Alternate Patterns" for more information.Manual Low Idle - Activate the manual low idle to reduce the engine speed to approximately 1000 rpm. Pressing the switch again will allow the engine speed to return to the original setting of the engine speed dial.The manual low idle allows the operator to reduce the rpm without touching the engine speed dial. Manual low idle is useful when the operator wants to reduce the engine speed to talk to someone or while the operator is waiting for a truck.Standard Machines
Illustration 2 g06224200
Vertical Slider Joystick Controls
(1) Left joystick switch 3
(2) Left joystick switch 4
(3) Left joystick switch 1
(4) Left joystick switch 2
(5) Left joystick thumbwheel
(6) Right joystick thumbwheel
(7) Right joystick switch 2
(8) Right joystick switch 1
(9) Right joystick switch 4
(10) Right joystick switch 3
Table 1
Joystick Configurations
Switch Location Machine Configuration
Grade Assist Payload Assist Payload
1(1) Hammer Hammer Hammer Hammer
2 Standby / Weigh Standby / Weigh Standby / Weigh Standby / Weigh
3 Horn Horn Horn Horn
4 Store Store Store Store
5(1) Work Tool Rotation Work Tool Rotation Work Tool Rotation Work Tool Rotation
6(1) Work Tool Open / Close Work Tool Open / Close Work Tool Open / Close Work Tool Open / Close
7 Bucket Recall and Store Bucket Recall and Store Bucket Recall and Store Bucket Recall and Store
8 Bench Mark Bench Mark Bench Mark Bench Mark
9 Grade and Bucket Assist Activation Grade and Bucket Assist Activation Grade and Bucket Assist Activation Grade and Bucket Assist Activation
10 Laser and Touch Point Laser and Touch Point Laser and Touch Point Laser and Touch Point
(1) Button is configurable on machines without tool control.