MOTOR GP-GEAR 4919530 - Caterpillar

SR4B
Remove the bearing bracket. Inspect the following items: bracket bore, bearing outer race and rolling elements. On standby power units, the bearing must be inspected and the grease must be replaced at 3 year intervals. The sleeve in the bearing bracket should be inspected for out of roundness, excessive wear, and a bracket step that is less than 0.0762 mm (0.0030 inch). If there is no sleeve in the bearing bracket, inspect the bore of the bearing bracket. The bearing should be inspected for damage to the outer race, severe fretting, and smoothness of operation. When possible, the bearing elements should be inspected. Some double shielded ball bearings prevent visual inspection of the elements of the bearing. Other double shielded ball bearings have a retaining ring. This retaining ring can be removed in order to allow access for a visual inspection of the elements of the bearing.On two-bearing generators, the front bearing can only be removed after the drive coupling is removed. Refer to the Systems Operation Testing and Adjusting Disassembly and Assembly, "Coupling - Remove" for the generator for instructions for removing the drive coupling.